10 gauge will suffice.
By the definition of power which is (p)=IV, if a 1500 watt Electric Fireplace is plugged in a 220v AC source, the expected current will be (I)=P/v. ie 1500/220=6.8A This is when the power loss due to cable resistance is neglected.
yes, 31watt divide 240v equals to 0.13amps.
It all depends on the supply voltage. In the UK the supply voltage is 240V therefore the amps would be 1500w/240v = 6.25A. In the USA (with a supply of 110v) the amps would be 1500w/110v = 13.64A. All you need to remember is the formula 'amps = watts/voltage'
If a load were only 240 volt on a single phase 240v system with a center tapped transformer the neutral conductor would carry no current.
It may not blow, but it will turn twice as fast and burn out very quickly. It is meant for 110 only. Check the sump pump. Some of them can be wired either 120v or 240v. If yours is like that, just wire the motor for 240v and plug it in.
Power adaptors are readily available that plug into Australia's 240v outlets, converting to 120v. Find them in travel, luggage and electronics stores.
i wld like to put lightson my motorbike but lights r 240v and bike is 9v how do i do it
By the definition of power which is (p)=IV, if a 1500 watt Electric Fireplace is plugged in a 220v AC source, the expected current will be (I)=P/v. ie 1500/220=6.8A This is when the power loss due to cable resistance is neglected.
need to know the capacity of the dimmer and the size of the lights
MM I'm not sure but in my text book it says that cows skin nd pigs can change it in Christmas or it says that electricity does Soz if it is wrong
Disregard the neutral
yes, 31watt divide 240v equals to 0.13amps.
yes
NO
With a transformer.
If the 240V 3-phase service is 240V phase-to-phase, then you can get 240V single-phase by simply picking two phases (poles, as used in the question) and connecting the load across them. This is simply one third of a standard delta connection. If you need 120V/240V split phase, i.e. with a neutral, as used in residential services, you will need a transformer. If the service is actually a four wire "quadraplex" service, however, you will probably already have that 120V/240V with neutral connection phase available. In this case, you will need to pick the two phases correctly in order to get the proper 120V service half.
It all depends on the supply voltage. In the UK the supply voltage is 240V therefore the amps would be 1500w/240v = 6.25A. In the USA (with a supply of 110v) the amps would be 1500w/110v = 13.64A. All you need to remember is the formula 'amps = watts/voltage'