0
Rover 200 Series
The Rover 200 is a small car manufactured between 1984 and 1999. Its third-generation model, codenamed R3, came with a five-speed manual or four-speed automatic transmission. This model became the seventh best-selling new car in Britain from 1996 to 1998.
475 Questions
Where is the reverse switch on rover 214?
Asked by Wiki User
For the 214 i removed the whole airfilter box... disconnected the switch..
Just incase anyone wondered.. its right below the air filter box.. ontop of the gear box
the 214 reverse switch is 22mm hex size.
What transmission fluid to put in rover 216?
Asked by Wiki User
Eurotaxolyslager says:
Manual transmission...
1.8 litres Q8 Formula F1 10W-50 Full Synthetic Engine Oil.
Automatic transmission...
Q8 Auto 14 Automatic Transmission Fluid. (no quantity given, but say, as a guess, at least 5 litres)
Where is the diagnostic plug for a rover 216?
Asked by Wiki User
down by the clutch pedel, closer to the radio tbh,
What does a rover do?
Asked by Wiki User
A rover brings tools and objects to the moon but it does not bring people.
What are the torque settings and tightening sequence for a 1.6 k series rover engine?
Asked by Wiki User
What_are_the_torque_settings_and_tightening_sequence_for_the_cylinder_head_bolts_on_a_Rover_200_K-series_engine
Where is the compressor clutch relay in 1999 rover 200 20 diesel?
Asked by Wiki User
The air conditioning compressor clutch relay is located on the bottom of the air conditioner compressor. The relay switch will be labeled.
Where is the cigarette lighter fuse in rover 200?
Asked by Wiki User
check out wiringdiagrams21.com for arover 214 itis 4 or 17
Where is reverse switch on 1994 prelude?
Asked by Wiki User
On the top of the transmission case, close to the passenger side mount.
Where is the location of the coolant bleed valve on a rover 220 coupe turbo?
Asked by Wiki User
on the top radiator hose.
Where is the main fuse for a rover 214?
Asked by Wiki User
The main fuse is in the engine bay fuse box located near the battery. It is the largest rated fuse, usually 60 amp or 80 amp.
What does it mean when the check engine light and cfc lights are on in 2001 Toyota 4 runner?
Asked by Wiki User
The computer has picked up on a problem in the engine that needs your attention. Could be bad could be just attention is needed. You need to check the code to be sure. If you go to the local parts store they will probably check the code for free and tell you what it is. Then gladly sell you the part that can fix it.
How long does it tke to fit a head gasket on rover 200 1.4 16v?
Asked by Pistonpete1
If you know what your doing a couple hours (head will need skimming) if not take it to a garage
How do you disable the immobilizer on your rover 416 sli?
Asked by Wiki User
you should have a 4 digit code that came with the car to remove this if your remote fob ain't working, if u not got code your local rover mg dealer will sell u one around £10 if UK spec car if not then u will need car alarm and immobilizer reprogrammed. this cost me £118 to get done because my car was registered in Ireland.
How do you enter the radio code into a rover 214 factory radio?
Asked by Wiki User
You need two U shaped pins that go into the 2 holes on either side of the radio, you push them in and the radio should just pop out. The pins can be made out of welding rod....
What are the torque settings and sequence for tightening head bolts on a land rover range 4.0 v8?
Asked by Wiki User
The torque settings are 40 to 45lb/ft for the outer row, 65 to 70 for the centre to inner row. Haynes (Methuen & Coomber 1999) doesn't specify any particular order for refitting the head bolts; follow the standard automotive practice of tightening the ones furthest apart and moving inwards.
