answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: A flywheel 12ft in diameter makes 80 revolution per minute?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does car speed at 1000rpm means?

Revolutions per minute is the # of times an engine makes a complete 360 revolution in one minute.


What is the linear distance traveled when a 2.5 diameter wheel makes one revolution?

If the rim doesn't slip on the ground, then the distance for each revolution is (diameter x pi).2.5 x pi = 7.854 (rounded)


Will repeated failed attempts to start a car result in a flywheel problem?

Not unless there was a problem with the drive gear on the starter that makes contact with the flywheel.


How many revolutions per hour does the minute hand move on big ben clock?

The minute hand of any analog clock moves 1 revolution per hour. (60 minutes to an hour) The second hand makes 60 revolutions an hour. (Each tick represents one second, one revolution per minute, equals 60 revolutions an hour.)


How much does bill gates makes a minute?

He makes approximately 600 USD a minute. (I think.)


When was Makes Revolution created?

Makes Revolution was created on 1996-08-12.


What makes your car make a grinding noise instead of starting?

starter not engaging flywheel properly. Replace starter, Checking for damage to flywheel while starter is removed.


A bicycle wheel makes 5000 revolutions in moving 11kmWhat is the radius of the wheel?

5000 revolutions in 11000m = 1 revolution every 2.2m Circumference is 2.2m Circumference is diameter times pi 2.2m dividied by pi divided by 2 (to go from diameter to radius) = 35.014cm


Why does the Starter on my grand am makes funny sound and not start the car?

Could be any number of reasons. Loose, bendix not engaging the flywheel correctly, worn out and bendix is chipping the teeth of the flywheel.


What is Mars' diameter from the Sun?

"Diameter from the Sun" makes no sense. Mars has a diameter of 6792 kilometers - a bit more than half of Earth's diameter.


Does the flywheel engage the gear?

No, the flywheel is bolted to the back of the crankshaft. It is a large metal disk with teeth around the outer edge for the starter to turn the motor. There is a smooth surface on the flywheel face. when the clutch is engaged it is catching the flywheel so to speak, by pressing the two surfaces together tightly. This makes them one and so the engine is now turning the gears in the transmission, which ever you have selected at the shifter. A flywheel is only in a manual transmission.


After replacing pull cord what makes the flippers extend to engage flywheel?

http://www.kalpol.com/electronic/snapper/