Diameter is 28 inches
If you have an 18 inch diameter sphere on top, you'll have a 36 inch diameter sphere in the middle and a 54 inch diameter sphere on the bottom. 18 x 2 = 36 and 18 x 3 = 54
This bag has a nine inch top diameter.
Three 0.50 inch diameter pipes will fit into one 1.50 inch diameter pipe (hypothetically). The 0.50 inch diameters stack on top of each other until you have 1.50 inches!
Top: 2 inch Sides: 1 inch Bottom: 1 inch
The top margin (and sides and bottom) is 1 inch.
Graduated means diameter is not uniform top to bottom.
Bore is the inside diameter of the barrel. depending on the nation, it may be measured from the bottom on one groove to the bottom of the opposite groove, or from the top of one land to the top of the opposite land (raised part of the rifling). Measurements can be to one thousandth of an inch. Thus a rifle with a .308 bore is .308 thousandths of an inch wide inside the barrel.
The 195 refers to millimeters (mm) and is the width of the tire across the treads. The 55 is also in millimeters(mm) and refers to the height if the tire from the edge of the rim(wheel) to the top of the tire. And finally, the 15 refers to inches (in) and refers to the diameter of the wheel that the tire fits to and the inside diameter of the tire.
The word for the top to the bottom of a circle is "diameter." The diameter is the longest chord of the circle, passing through the center and connecting two points on the circumference. It divides the circle into two equal halves.
no i dont think so i got 20's on my 2001 alero and i only got about a inch left from the top of the tire to the bottom of the strut and a only got a 225/30/20 tire The tires/rim size is listed right here. Tire size - 215/60/R15" Rim Size - 15" So I am not so sure about 22 inch rims. You might want to consult a Mechanic.
They will increase top speed and make acceleration slower
Measure the distance from top left corner of square (or top right) to the bottom right corner of square( or bottom left) to get the diameter of the circle. Then calculate the circumference from that figure.