0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is a spring caliper used for?
There is no spring caliper.
What is the spring constant of a spring?
The ratio of force applied to how much the spring streches (or compresses). In the SI, the spring constant would be expressed in Newtons/meter. A larger spring constant means the spring is "stiffer" - more force is required to stretch it a certain amount.
What is the length of the spring when a weightof 10n hangs from it?
depends on the initial length of the spring, and how much force is required to stretch the spring
What units do you use on the spring scale?
The unit used on spring scales is 'Newtons.'
What is the formula to find the spring constant?
F = - k x In this equation, x is the distance that the spring has been stretched or compressed away from its equilibrium position F is the restoring force exerted by the spring. k is the spring constant.
What features involve compression?
It implies characters and plot in very few words.
A 1.2 kg of cheese is placed on a vertical spring of negligible mass and a force constant of 1800 N over m What is the length of compression of the spring?
Length of compression of the spring = (1.2*9.8)/1800
How much do replacement compression springs cost?
Compression springs cost about $3-$5 per spring.
TENSION?
The pull or compression of a string or spring at both of its ends
Is there a difference in the spring force when the spring is compressed instead of stretched?
When a coil spring is compressed the spring compression tends to vary inversely with the length of the spring to the point where the spring cannot be compressed further without damage. In tension, the spring tension varies directly with the length but only so long as the elastic modulus is not reached. At that length, the spring becomes permanently deformed or "sprung". Depending on the representation of the drawing, the vector of the spring in compression will be opposite that of the same spring in tension. That is to say, if you push the spring to the left the force will be negative while a pull to the right will be positive so the spring in compression will push right (positive) and the spring in tension will pull left (negative).
State a difference and similarity between an extension spring and a compression spring balance?
both are instrumental devices used in physics
How do you adjust the velocity on an air soft gun?
new spring or check your compression.
What are all the advantage of helical spring?
Because it handles both tensile (Expansion) load & Compression Loads...
How do you replace the fuel filter on a 1995 Lincoln continental?
Replacing Lincoln Continental fuel filters requires a spring expander tool. The fuel filter and the fuel lines to the injectors are held in with a circular spring housed in the end of the line. The line itself that the spring clamp slides over has a raised part on the line, and when the spring connector is pushed over this section, the clamp expands to go over the raised section and then collapses once more on the other side, holding the two pieces together. The spring expander tool is a small L-shaped expander the fits over the line and when pushed into the spring expands the spring so it will enable the pieces to be separated.
Define spring constant What is its unit?
The rate or spring constant of a spring is the change in the force it exerts, divided by An extension or compression spring has units of force divided by distance, law which states that the force a spring exerts is proportional to its extension.
What is an example of an out put force?
Release of a spring from compression Recoil of gun after firing a shot
What is compression spring balance function?
to know the mass of a object
