Want this question answered?
Diameter.
To measure ID of pipes and cylinders.
Plumbers commonly need to use fractions in their career. The reason for this is that the pipes that they use is measured primarily in fractions, such as 1 3/4' pipe. Plumbers often have to custom make fittings, which requires them to be able to calculate in fractions in order to get a good fit.
No, aqueducts were used to carry water. They were big water pipes which carried water to wherever it was needed.No, aqueducts were used to carry water. They were big water pipes which carried water to wherever it was needed.No, aqueducts were used to carry water. They were big water pipes which carried water to wherever it was needed.No, aqueducts were used to carry water. They were big water pipes which carried water to wherever it was needed.No, aqueducts were used to carry water. They were big water pipes which carried water to wherever it was needed.No, aqueducts were used to carry water. They were big water pipes which carried water to wherever it was needed.No, aqueducts were used to carry water. They were big water pipes which carried water to wherever it was needed.No, aqueducts were used to carry water. They were big water pipes which carried water to wherever it was needed.No, aqueducts were used to carry water. They were big water pipes which carried water to wherever it was needed.
Elbow is a fitting used to change pipe direction, 45 degrees in this case, LR is referred as "long Radius" ( normally most pipes, unless you ask for SR, short radius). Butt weld refers to welding 2 ends from two separate fittings or pipe. Both ends are beveled (30 degrees is tapered from inside pipe diameter to outside pipe diameter on pipe/fitting connections)
Diameter.
No, The refrigerant within the system is on the inside of the pipes and the water condensing on the coils from the moisture in the homes air and running out of the drain is on the outside of the pipes.
corrosion or rust are about the only terms I am aware of. Inside or outside doesn't matter.
they got the water inside by using pipes from the outside and connect them underground to the inside and let the water flow when they wanted it to.
Asbestos was used in many different building materials, including asbestos-concrete pipe (a common brand name was Transite). It is generally not found inside metal pipes- it WAS used as insulation on the outside of pipes.
The energy comes from the heat taken from the heat/energy inside of the refrigerator/fridge. A fridge takes heat energy from inside the fridge and dumps it outside the fridge into the the pipes on the back of the fridge and into the room.
both ID inside diameter and OD outside wall thickness is determined by sch 40 ect the higher the number the thicker the wall pressure pipe should be a higher rating c900 PVC can go to 200 psi ductile and steel up to 600 psi non pressure pipe is a sch 35 usually
If the basement has ventilation to outside, the answer is yes. Heat loss from the pipes will escape outside the house. If the basement is closed to the outside then no, the pipes need not be insulated. Any heat lost from the pipes will provide some heating to the basement that will rise into the house.
Tube and pipe are both used for conveying liquids or gases under pressure. They differ in how they are sized and their rigidity. A conduit is mainly used to protect and route electrical wiring.
to measure inside diameters of pipes
With a paintbrush.
You must mean in DRAIN pipes. -It can not be used in plumbing pipes.