An amp can only put out so much power without distortion. A speaker, say, a subwoofer, will utilize whatever the amp is able to put out. So the question is not will a speaker fry an amp, but whether the amp will blow the speaker. (Not, in your example)
Any speaker, though, needs a certain amount of power to begin to drive it to listenable levels. High-efficiency speakers like bass-reflex speakers need only 5 or 10 watts for loud levels, while a low-efficiency speaker may not even make a squeek until they are fed with 10 to 15 watts of power.
sO will this set up work or not?
you handle them by combing them to make one great drug
It depends on how you handle glass objects.
no it is not because it is not safe to handle
is neon safe to handle
Explain how to handle the following computer Cans: Answer text
The Rockford Fosgate R150-2 2-channel amp puts out 50 watts RMS per channel to your speaker system, or you can bridge it to supply 150 watts RMS to a subwoofer.
The solo x is a bad subwoofer it can handle a lot of wattage and will break windows. JLs is a good sounding sub but probably cant handle as much wattage as the solo x
Well, it depends. When you look at subwoofers, it will say RMS and peak. Now, let's talk about the "RMS" and "peak" on the subwoofer. The RMS is the real power. That's what were gonna be looking for. The RMS is the continuous power design for the subwoofer to operate. The peak is the maximum power the subwoofer can handle. Obviously, were not gonna be running the subwoofer with its peak power because that will decrease the life of your subwoofer. Running too much power or too little can damage your subwoofer. It's also important to run it by it's RMS rating. So, I don't know if that 450 watt is the RMS or peak. I'm assuming that it's the RMS. As long as you don't bridge it, it should be fine.
The Kicker 08DS12L72 can pump out up to 1500 Watts, but you'll need a beefy receiver for that.
No.That's a common complaint among buyers actually.They regret not getting a player which could handle MP3s.
Yes and it should ge available at the parts store pretty cheap.
It is a metal blade that is crescent - moon shaped with a wooden handle. In the pioneer days or even before then it was used to cut wheat, tall grasses, and weeds ( those sorts of things)
well each type x subwoofer can handle 3000 watts max and 1000 rms (recomended) so about a 2000 watt amp should give u unbelievible bass, if u have 2 alpine type x 12's u need can handle 6000 watts and 2000 rms
You need to make sure the impedance matches or you will blow you amplifier! It would be best to replace it with the same brand as the speakers, feed it with a digital cable. There won't be a problem of overloading your amplifier.
If your home receiver is not rated for a 2-ohm load (many can handle a 4-ohm, but not a 2-ohm), you will damage components inside the amplifier by over-current. Don't use car stereo components in home stereo equipment. It's like using a hockey helmet to ride a motorcycle.
Technically, yes. Practically, no. Amplifiers and speakers are rated by the maximum amount of power (and at what impedance) they can handle. A 1200 watt amplifier will eventually destroy a 1000 watt speaker if it is operated at maximum power. In normal use, however, you rarely even get close to maximum rating.
file or straight handle, pistol grip handle and woodsaw handle