False. The minimum Service Drop Conductor size is a #6 Copper 75 Degree C and 90 Degree C Insulation or 60A. You would need a #4 or better in Aluminum with the same insulation values.
disconnecting the battery for a few minutes usually does the trick.
Yes, if the switch is sufficient for the circuit requirements and it is installed in sight of and within 50 feet of what it disconnects.
A cable terminal is a fixture designed to be installed in the end of a cable or conductor in order to facilitate the connection.
A memory saver should be installed prior to disconnecting the battery from a vehicle so all of the personalized settings of the car owner will be saved. If this is not done, all radio stations as well as security codes for radio theft program and car alarm will have to be reset. many car owners do not have these codes and have to contact the dealership to gain access to them once they are cleared from the system.
3/0 awg wire
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
the unit of admittance (Y) in A.C parallel circuit is
The radio in a 2002 Buick Century is changed by removing the bezel, disconnecting the wiring harness, and removing the retaining screws. It can then be pulled from its mounts and a new radio installed.
The starter on a 92 Buick LeSabre is replaced by disconnecting the battery, removing the retaining bolts, and lowering the starter. The wiring harness can then be disconnected and a new starter installed.
The oil pressure sending unit is removed by disconnecting the wiring harness and unscrewing the unit using a wrench. The hole is then wiped clean, a new unit installed, and the wires reattached.
14 Guage Cu
Try disconnecting the battery for 10 minutes to see if it will reset--if not have engine scanned Try disconnecting the battery for 10 minutes to see if it will reset--if not have engine scanned