It depends on the rms of the two cvrs combined. Also if the 1200 watt amp is 1200 watt rated (rms) or 1200 watt peak. Lets say the two kickers have an rms of 600 watt each, and the amp is 1200 watt rms, which it probably isnt but i'll pretend. This set up would work because 600 of the amps watts would be correctly matched with one sub, and the other 600 would go to the other sub.
To power two 300 watt subwoofers, you will need an amplifier with a maximum power output of at least 600 watts. It is recommended to choose an amplifier with a slightly higher wattage rating to ensure that the subwoofers receive enough power for optimal performance.
Need to know the voltage the amp operates on.
It will have the potential to over drive the speaker elements and can cause distortion and potential speaker damage.
It depends on the specific power-handling capabilities of the subwoofers and their impedance. If the subwoofers have a total power handling capacity that is lower than 300 watts and the amplifier can provide enough power at the required impedance, then it should be able to adequately power the two tens. However, if the subwoofers have a higher power handling capacity or the amplifier cannot provide enough power, it may not be sufficient.
1200 Watt wiring is more than enough for an 800 Watt amp. The rating of the sub doesn't make any difference to the cables. If you want to use the sub to its rated power you should get a bigger amp. If the amp can only give out 800 Watts and the sub can take 1100 Watts then you can put a bigger amp on. It is still going to be loud as with an 800 Watt amp. I have a 300 watt amp with a 1200 Watt sub and people hear me coming.
It's actually a good idea to have a speaker that can handle higher wattage than the amp can produce.
They can be as loud, as the amp is not delivering 600 watts. The 10" sub rated at 600 watts is able to withstand more power.
800 watt should be fine
It depends on the rms of the two cvrs combined. Also if the 1200 watt amp is 1200 watt rated (rms) or 1200 watt peak. Lets say the two kickers have an rms of 600 watt each, and the amp is 1200 watt rms, which it probably isnt but i'll pretend. This set up would work because 600 of the amps watts would be correctly matched with one sub, and the other 600 would go to the other sub.
crutchfield has a wiring diagram for all kinds of configurations, check it out.
Depends on what your willing to spend.. For two 1200 watt subs I would go with a 1200 watt amp and run both of then 600 watts ( you don't want to always run subs to full power, because the voice coil might blow or you will light your subs on fire). If your feeling brave you can run a 2000 watt amp 0_o that will annoy your neighbours, but make your car bump!
Yes, but the amp is too powerful and if turned up to full volume will blow the speakers.
1000-1200 watt peak amp its rated at 350RMS and breaks at 1200 watts so ether a 500-600RMS should do fine and sound killer
A #8 conductor is rated at 40 amps. Wattage is the product of amps x volts. As you can see the voltage is needed in this question to answer it. In the electrical trade I have never come across the terminology watt amp. Volt amp, yes.
Yes!!!!! Do not try it unless you want to get to very hurt!!!!!!!!
you just need one, a general rule of thumb is that the wattage on your amp should be double the wattegae on your sub, hence if you have a 1200 watt sub you'll need a 2400 watt amp