Yes, this is possible and can be done. The single modulation type can be employed in such a way as to maximize data throughput at all viable values of SNR.
No, Aristotles is not single.
single
A single number cannot have a percentile.A single number cannot have a percentile.A single number cannot have a percentile.A single number cannot have a percentile.
I think you can round a single number?
25811 is a single (5-digit) number and a single number does not define a sequence.
Suppressed carrier single sideband amplitude modulation - SCSSBAM.
single sideband full carrier
amplitude modulation is used
Maximise its profits
PPM is a type of pulse modulation where messages are sent using single pulses. PWM is a type of modulation which conforms to the pulse. PAM is a type of modulation in which the information is encoded into a series of pulses.
There are actually 4 forms. The first and most common is AM, the next is SSB or Single Side band, the third is FM (Frequency Modulation) and the fourth is Digital
Analog modulationIn analog modulation, the modulation is applied continuously in response to the analog information signal.Common analog modulation techniques are:Amplitude modulation (AM) (here the amplitude of the modulated signal is varied) Double-sideband modulation (DSB) Double-sideband modulation with unsuppressed carrier (DSB-WC) (used on the AM radio broadcasting band)Double-sideband suppressed-carrier transmission (DSB-SC)Double-sideband reduced carrier transmission (DSB-RC)Single-sideband modulation (SSB, or SSB-AM), SSB with carrier (SSB-WC)SSB suppressed carrier modulation (SSB-SC)Vestigial sideband modulation (VSB, or VSB-AM)Quadrature amplitude modulation (QAM)Angle modulation Frequency modulation (FM) (here the frequency of the modulated signal is varied)Phase modulation (PM) (here the phase shift of the modulated signal is varied)
An advantage of a single side band (SSB) is that it only needs half the bandwidth of AM. AM stands for amplitude modulation.
Single side band suppressed carrier modulation is like amplitude modulation except that one of the sidebands is suppressed or filtered out. Each sideband carries the same though opposite, information, so suppressing the one sideband allows more power to be placed into the one remaining sideband. The downside, of course, is that the demodulation process is more complex.
Amplitude modulations can be used to transmit binary data. Remember AM modulation is done using a single carrier frequency, and increasing or decreasing the amplitude. A high amplitude would be considered a '1', and a low amplitude would be considered a '0' (typically).
Multi-carrier modulation (MCM) is a method of transmitting data by splitting it into several components, and sending each of these components over separate carrier signals. The individual carriers have narrow bandwidth , but the composite signal can have broad bandwidth.
Pulse-position modulation (PPM) is a form of signal modulation in which M message bits are encoded by transmitting a single pulse in one of 2M possible time-shifts. This is repeated every T seconds, such that the transmitted bit rate is M/T bits per second. It is primarily useful for optical Amplitude_modulation_compared_to_Pulse_position_modulation'systems, where there tends to be little or no multipath interference.Read more: Amplitude_modulation_compared_to_Pulse_position_modulation'This answer is lifted from response to "Amplitude modulation compared to Pulse modulation", so the original answerer gets credit for a great answer.