Most local codes require that when extending or adding circuits, the circuit must be brought up to national code standards. This would necessitate that if you have a 2 wire circuit and are adding to it, that you rewire the entire circuit to 3 wires.
However, in actual practice, it is common to see 3 wire nmb connected to 2 wire nmb without full re-wiring. It is important to note that when this happens, the ground wire in the 3 wire cable serves no purpose. You end up with what looks like a 3 wire grounding configuration at a receptacle or other outlet when in actuality you have no equipment ground. This allows a hazard to exist that no longer conforms to current code, and if someone were to be injured you may be held liable.
yesAnother (corrected) answer.NO! The circuit breaker is there to protect the wiring from overheating. It wouldn't matter where on the circuit you decided to put the 14 gauge wire, you would need to change the breaker to 15 Amp if you did that. Using 14 gauge wire on a 20 amp circuit is a fire hazard and contrary to UBC. Contact your local building and zoning department to verify.
The larger the wire gauge, the smaller the diameter. 12 gauge is bigger than 14 gauge.
The lower gauge number is always a thicker wire which can carry more current.
When looking to purchase a 14 gauge speaker wire it may be possible to buy the required length and brand of wire from a local Hi-Fi shop. There are online websites that offer 14 gauge speaker wire and these are sites such as Amazon and Walmart as well as many other sites that offer speaker wire.
The wire sheathing itself is usually marked. e.g. 14 CU 2 or 14/2 CU will indicate 14 gauge 2-wire (+ ground) copper (CU being the symbol for copper on the periodic table). For 15amp circuits you will likely has 14 gauge wire with most of that being 14/2 (Usually white, black, and bare copper).
16 Ga wire is smaller than 14 Ga. The answer is absolutely NO!
yesAnother (corrected) answer.NO! The circuit breaker is there to protect the wiring from overheating. It wouldn't matter where on the circuit you decided to put the 14 gauge wire, you would need to change the breaker to 15 Amp if you did that. Using 14 gauge wire on a 20 amp circuit is a fire hazard and contrary to UBC. Contact your local building and zoning department to verify.
no
it is not recommended because the 14 gauge wire is not capable of carrying the same amount of load as the 12 gauge wire which could result in a fire.
The gauge of wire that is 12 volt is 18, 14, and 16.
The larger the wire gauge, the smaller the diameter. 12 gauge is bigger than 14 gauge.
The lower gauge number is always a thicker wire which can carry more current.
They are close but not the same. For example, 14 gauge steel is .0781 inches thick while 14 gauge steel wire is .083 inches thick.
No - the two have no relationship to each other at all.
0.064084 diameter
It is better to use 16 gauge or 14 gauge speaker wire for your home theater applications.
When looking to purchase a 14 gauge speaker wire it may be possible to buy the required length and brand of wire from a local Hi-Fi shop. There are online websites that offer 14 gauge speaker wire and these are sites such as Amazon and Walmart as well as many other sites that offer speaker wire.