Yes you can. 8 ga. is better and more efficient than 12 ga. It will only benifit your install
To answer this question fully the type of appliance has to be stated and its voltage.
it is possible to .connect two led in reverse polarity. and then one end connect with a 100k resistance then it can connect directly to230 volts
Mainly to prevent electrical shocks to the user of the appliance. Also helps keep the appliance from being damaged. <><><> The purpose of the grounding pin or prong is to connect the metal casing and any metal parts inside the appliance straight back to ground independently to the neutral wire. Then, if ever the metal casing or any metal parts inside the appliance become electrically "hot" or "live" because of an equipment failure, accidental damage - or some other cause of a malfunction - the direct path back to ground will in effect produce an immediate short circuit that will make the fuse or circuit breaker, that is protecting the circuit supplying current to the appliance, to operate to break the supply of current. By doing so, it helps to prevent electrical shocks to the user of the appliance. For more information see the answer to the Related Question shown below.
The purpose of a circuit breaker in a panel is to protect the wiring and devices like switches, outlets and other devices that are part of that circuit. It isn't unusual to plug in an appliance into a circuit whose amperage rating is less than the breaker protection. If such an appliance doesn't have its own over-current protection it may well "fry" in an over current situation. However, if your 40 Amp device is directly connect to the 70 A circuit and has no over-current protection on its own you are risking a serious problem. If your 40 A device is on this dedicated circuit you should protect it with a properly sized breaker.
Electrical cord is also refered to as power cord, line cord, and main cable. Electrical cord is mainly used to connect the appliance to the main electricity supply via wall socket.
A Mesh Topology
A network appliance is a home appliance that can connect to control devices wirelessly. Lights can be turned on or ovens pre-heated remotely at the push of a button.
Composite cables are used to connect the audio and video components from a electronic appliance to a television or monitor. A DVD player or video game console, for example, requires the proper connectivity of these cables.
No
The basic difference between the microprocessor and microcontroller is that we can interface a microcontroller directly means "for example we can directly connect a keyboard to microcontroller to any of its ports"....where as for microprocessor we can't interface directly...we require a circuit board since it requires ram,ic's.....etc.,! beyrojac mahinay
I believe the rule of thumb is 10% either way and you have exceeded that.
You cant do this directly. However you can connect them both to the same Amazon account.
An Outlet has two nodes, one is positive and one is negative. You will not feel anything to a negative node and it is for receiving the supply of electricity released from positive node. As you connect a appliance to outlet the electricity has to pass through out that appliance to reach to the negative node.
DMA
no.
take a solar panel & add wires on the panel & connect these wires to the small appliance!!!!
To answer this question fully the type of appliance has to be stated and its voltage.