Yes you can. There are three ways of doing this. Two are incorrect and one is the correct way of doing it.
The two switches can be paralleled together to make the light fixture respond. Both of the two switches will always have to be in the on position. Either switch will turn the light off but the second switch will not turn the light on. Very inconvenient when you enter a room through one door and leave by another.
The two switches can be wired in series. Both switches have to be on to operate the light but again if one of either switch is left in the off position the other switch will not operate the light fixture. Very inconvenient when you enter a room through one door and leave by another.
The correct way of wiring two switches to control a central light fixture is with a three way switching system (two way in the UK). The two positions have to have special three way switches in each position. These types of switches sort out the problems of leaving a switch in a certain position to operate properly. The only criteria is that there be a three conductor cable joining the two three way switch boxes together.
See related links below.
go to the Help option in Matlab. It will not help at all.
yes
If a single pole switch is wired to be a master switch, the switch would have to be in the on position for any other control devices to operate. Turning the master switch off would eliminate power to all devices (and/or loads) which it was serving. For example, some homes have a switch to control their outside light. If the outside light has a photo eye (the light will only come on at night), the switch is the master switch. Another example would be the breakers in an electrical panel. Each breaker would be the "master switch" for the circuit it protects. The main breaker in the panel would be the "master switch" for the entire home.
A single phase switch only has two screws to connect power One is the source (or panel power coming in) the other is for the load or device requiring power ( power out) this is referring to residential applications.
Connect the incoming power to the line side of the GFCi outlet. Now run another wire connected to the line side of the GFCI outlet from the GFCI outlet to the switches. Power one of the switches and use that switch to turn on the 2 lights. Run power from that switch to another switch and use that switch to send power to the fan. Mount both switches in a double pole switch box. If the light above the sink has an outlet on it then you will have to connect power going to that light on the load side of the GFCI outlet. If not then just connect it to the line side.
To control a light with a switch, the switch has to be connected in series with the light fixture.
Yes, make sure you wire it correctly. Some switches connect across the screws and some connect like a conventional switch where the screws are below one another.
You connect up to 5 devices with HDMI cables to the switch, and connect the switch output to your TV with another HDMI cable. You the selector switch or the remote to go between the devices.
to connect similar devices..like one switch to another switch
to connect similar devices..like one switch to another switch
A switch is typically used to connect multiple computers in a single residential unit to a modem.
KVM switch
A router or a Layer-3 switch can connect 2 or more LANs together and control data flow between them.
Connect a router to the DSL modem, and if necessary add a switch to the router. Then connect all of your systems to the switch and the router.
go to the Help option in Matlab. It will not help at all.
To connect two devices of the same type together. e.g. You would use a crossover cable to connect a router to another router, a switch to another switch or a computer to another computer. If you are connecting diferent devices together, such as a router to a switch, a straight through cable should be used.
yes