I wouldn't, always safer to go heaver gauge. I recommend 8 gauge if you are going to be running any length of wire. Fire is never fun
I believe the above answer assumes the question was meant to read, "30 amp 220 volt dryer."
12 gauge wire WILL NOT carry 30 amps safely. You need to run #10 copper minimum. It is never a bad idea to upsize, such as the recommended #8, but it is not necessary if 30 amps is what you need.
If you are no longer using the dryer and there are 4-wires, and the dryer was 220 to 240 volts, it can be split into two 110 to 120 Volt circuits.
No !
What gauge of wire is required to carry a certain amperage X number of feet? How do you break out a 120 volt circut from a 3 phase line? When installing a load center, how should the ground be installed? What locations require Ground Fault Interrupters to be installed? How should a 240 volt dryer plug be wired? What is the minimum size conduit that 3 0 gauge wires can be pulled in? Can 12 guage Romex be used to wire a water heater?
If your load runs on 6 volts, you cannot replace it with a 12 volt battery. You will be exceeding the voltage rating of your load and will start a fire.If you want more amps (capacity) then you can wire more 6 volt batteries in parallel with the first.
No and it wouldn't work. The wires in a standard plug (#14) even at 240 volts would not be large enough to handle the 30 amps (#10) that a dryer would need.
Two 6 volt batteries connected together in parallel will still maintain 6 volts but their amperage capacity will be doubled.
If you connect them in series the Voltage will double but the Amp Hour Capacity stays the same. Click the link.
No, you can not hook up a 12-110 volt inverter to a house socket.
Because a toaster does not pull near the current that a cloths dryer does.
Because a toaster does not pull near the current that a cloths dryer does.
Hook a 12 volt light to a 24 volt system and the light will burn out in seconds. You need a step-down voltage converter to do this.
in series
The temp gauge sensor screws into the driver side head atoms #2 and #3 plugs. The volt gauge hooks up to any ignition on hot wire and the other wire to chasis ground. Oil pressure gauge is just behind the distributor.
The gauge of wire that is 12 volt is 18, 14, and 16.
Separate the 2 12 volt batteries and charge them individually.
Yes
Yes - a hair-dryer rated at 120 volts will work in a 110 volt outlet.