Yes, but it must then be clearly labeled that it is only for devices that are dimmer compatible (no motors, no fans, no computers, no nondimable lights, etc.) This might reasonably be done for an outlet that is dedicated to a single lamp.
However some electrical codes may prohibit this (even though it can be done) for safety.
a shorted out outlet can cause a backfeed on the white wire, an open circuit on the white wire with and electrical appliance plugged in to an outlet can cause the same type of backfeed
Look on the carton that the dimmer comes in. On the label there will be a list of lamp types that the dimmer can be used on along with the maximum wattage that the dimmer can control.
A dimmer switch is very helpful as if you attach one to your light switch you can control your light intensity, the Lutron Dimmer is a brand dimmer switches that provide high quality performance.
just leave the neutral wire as it is and connect the other two !!
you can find it in alldata
You can wire a dimmer into any circuit. The issue is where you do it for a specific outlet. The dimmer would just have to connect to a single outlet and not all outlets on the same circuit. The issue is getting a dimmer that is compatible with the device you are dimming. Some lighting requires special dimmers.
12v switched source. such as headlight switch or dimmer on the dash.
You don't.
See: "How can you re-wire a wall switch that controls an outlet to control a ceiling fan?" (Follow the link below.) The procedure is the same whether the new device is a light fixture or a ceiling fan.
It would go to the dimmer that controls the brightness of the dash lights.
a shorted out outlet can cause a backfeed on the white wire, an open circuit on the white wire with and electrical appliance plugged in to an outlet can cause the same type of backfeed
Don't connect the red wire or you will die.
No, that is not unsafe.
If you have one wire into your switch box for your light. this is called a switch leg, the dimmer should be wired across the black and white wire wires.
Look on the carton that the dimmer comes in. On the label there will be a list of lamp types that the dimmer can be used on along with the maximum wattage that the dimmer can control.
Ground wire is loose or disconnected somewhere in that circuit.
# 6 wire