answersLogoWhite

0

Check the tires! More than once, and just last week a bad tire was the cause of some interesting shakes, shimmies and wobbles. The steel belts inside the tire will separate and may not always be easily seen by the naked eye. A good tire shop can readily check the balance of each wheel. A $25 used tire and balance resolved my problem.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

What are possible causes of brand new motor mounts to break on a 1994 Jeep Grand Cherokee Limited with 140000 miles within 21 days of installation?

It is possible that the transmission mounts were also bad causing the engine mounts to go bad. also check the transmission crossmember is tight and not missing any bolts or nuts.another least likely problem could be bad half shafts Axle shafts or drive shafts causing excessive vibration also out of balance large off road tires (again excessive vibration) Hope This Helps


Will the engine and transmission from a 2003 Chevy Trailblazer fit into a 1999 Chevy s 10?

This is an engine swap and will require engineering mounts, drive shafts, computers and wiring.


What things have an universal joint in it?

Drive shafts, PTO shafts, Steering shafts, Axle shafts,


Why does my truck knock when I engage four wheel drive?

propellor or drive shafts loose or worn or transfer case loose from tranny or bad frame mounts possible hubs need looking at


What would cause Ford Taurus engine to knock?

Same as any engine. If your gear shift is moving as well it will possibly be your engine mounts. If its been happening when cornering check your drive shafts.


Where ar barbules and pinnae connected to the feather of birds?

shafts Barbules and pinnae are connected at the shafts of the feathers. This is on a bird.


What is the purpose of timing balancer in 92 Honda 2.3 motor?

I assume you are referring to the two balance shafts that are driven by the small belt which is behind the timing belt. These shafts are there to cancel out the vibrations that occurr because the piston/connecting rod assemblies are changing direction twice per revolution of the engine. This results in less vibration being transferred through the engine mounts to the chassis. Be aware that these shafts must be in time with the crankshaft as does the camshaft. Hope this was helpful.


I have a 2002 Chevy Malibu with a 3.1 eng automatic trans.My question is What causes the trans to clunk when shifting from park into drive or reverse?

The rubber isolators in the engine mounts have worn out or the CV joints in the drive shafts are worn out.


What are the different types of bike shafts available for purchase?

The different types of bike shafts available for purchase include solid shafts, hollow shafts, and splined shafts. Solid shafts are one continuous piece of metal, while hollow shafts have a hollow center. Splined shafts have grooves that fit with corresponding grooves on other bike components. Each type of shaft has its own advantages and is used for different purposes in biking.


How Do I Change transmission in a 1989 Ford Taurus?

lots of work , unbolt front sub frame , pull tires ,lower balljoints ,exaust,half shafts,unbolt trany from engine and pull all connections .undo the motor and trany mounts and hold up engine and unbolt tourqe converter lots of work , unbolt front sub frame , pull tires ,lower balljoints ,exaust,half shafts,unbolt trany from engine and pull all connections .undo the motor and trany mounts and hold up engine and unbolt tourqe converter


What causes severe Car engine noise when driving in gear but not when stopped?

Could be one or more of the following factors: A problem with the gear box, Worn engine mounts, worn drive shafts, may also be other factors involved.


Can a 2002 jeep be towed on a dolly?

Only with drive shafts removed.Only with drive shafts removed.