0
1. a,b,c
2. b - results to UCC
3. 1- remove a half sheet of m8 paper... 2-Dip the paper into the liquid 3-Observe the m8 paper for color changes 4-compare any color change 5-report results 6-discard m8 paper
4. d - It changes color
5. a - red
6. b - black
7. a - Exhaled air is directed through the outlet valve and front module covor
8. b - local logistics readiness flight personnel will measure your face length using a caliper
9. b - it will leak causing possible illness or death in a contaminated environment
10. b - sitting erect with your head level, your mouth closed, and your teeth lightly together
11. b,c,e - upon issue, prior to turn-in, prior to deployment
12. d - immerse the mask in the disinfecting solution
13. a,c,e - The threads are damaged. It is dented deeper than 1/4 inch. It is dented on a seam.
14. a - turn in the mask
15. c - 1/4 inch
16. b - replace the harness
17. d - Separation of the silicone from the metal surface to which it's bonded
18. d - turn in the mask
19. a - the straight side of the D-ring on the shoulder strap of the carrier
20. b - incorrect installation may cause toxic agents to leak into the mask
20a. outward
21. b - fit the narrow rib into the groove where the lens and the mask are bonded
21a. a - replace it with a new second skin
22. a - large rib at the bottom, facing outward
22a. a - install the second skin around the drinking tube
23. c - With the front voicemitter toward the open end of the bag
23a. b - force the air out of the bag
24. c - make sure long hair is tied back and hangs outside of your GCE jacket
25. c - Run a finger under each temple tab, front to back.
25a. c - loosen the neck straps
26. c - you perform the negative pressure check and the lens remains deflected after holding your breath
26a. b - by the front of the facepiece
27. a - stop breathing and close your eyes tightly
27a. c - 9 seconds
28. a - determine proper fit -- if the lens remains deflected, this give an indivation of an initial proper fit
29. a - reverse it over the face of the mask
29a. d - place the m50 head first and the m45/mcu-2 filter first and upright facing away from the body
30. d - hook-and-pile fastner tape at the fly
31. a,b,e,f - The manufacture date, part of the national stock number (NSN), the contract number, garment size
32. a,b,e - centered in the middle of the back of the hood, horizontally above the eyelens on the front of the hood, over the right breast of the coat
32a. d,c,e - first and last name, rank, service component
33. d - wash it
33a. a - by marking the labels inside the coat and trousers
34. a - over the combat boots
35. a - outer gloves and glove liners
35a. c - to protect your feet and ankles from contamination
36. c - to protect your feet and ankles from contamination
37. b - Secure all overgarment fasteners on each ankle so that they fit snugly around the protective footwear.
38. c - leather gloves
38a. a - 2 minutes
39. a - 32F
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What are the answers to ss 3 module 2?
At Answers.com you can ask specific questions, but you can't ask for the answer key to your textbook. Do your best with the assignment, then check it in class. :)
What are the Foolproof Module 3 test answers?
There are not any What are the Foolproof Module 3 test answers online. Preparing for the test through reviewing the study materials is best.
How do you calculate face width per gear?
Its is taken standard as 2*pitch circle diameter - 3**pitch circle diameter for cast teeth. 3 *pitch circle diameter - 4 *pitch circle diameter for cut teeth. Pitch circle diameter = PI*module regards, Pranav
How-to 3 3 3 3 3 equals 31?
(3 to the power 3) + 3 + (3/3) or 33-3+3/3 or 3/3+3+3to the power of 3
What is 3 ft squared?
3FT [] or [3]ft or 333333333 3 3 3 3 3 feet 3 3 3 333333333
What is the name of ECDL module 3?
In syllabus 4.5 and syllabus 5 Module 3 is word processing. Thanks Litmus Learning
What are the answers for ssd level 3 module 3 test?
NO CHEATING! -Your teacher
How ment seats are there in Apollo?
The Command Module has 3 seats, the Lunar Module has 0 seats (they stood up to fly).
What is the difference between a module and a pattern?
A module is a 3-dimensional motif, and a pattern is a 2 dimensional decorative visual repetition.
Where is the ignition control module located on a 1992 Chevy Berretta?
ignition module is located under the distributor, where the spark plugs come out to go to the spark plugs, remove 6 bolts that hold the 3 capped distributor on, unplug the wires from both ends of module, 3 plugs, lift module out, nothing holds it in after distributor is removed, plug new module in, replace distributor.
Difference between ECDL syllabus 4 and syllabus 5?
The last registrations for Syllabus 4.5 will be taking place at the end of August. The differences are as follows. Module 4.5 Module 1 - Basic Concepts of It Module 2 - Using Computer and Managing Files Module 3 - Word Processing Module 4 - Spreadsheet Module 5 - Databases Module 6 - Presentation Module 7 - Info & Comms Module 8 - Unit E The changes were as follows. Syllabus 5 Module 1 - New module - Security for IT users Module 2 - IT User Fundamentals is Syllabus 4.5 Module 1 and some of Module 2 Module 3, 4 & 6 are the same, Module 5 Databases / Access is still available but only as a stand alone module. Module 7 - Has been updated to Using Email and the Internet Module 8 - New module - Improving productivity using IT (using word OR Excel OR Powerpoint). Please note this answer is based on the UK Syllabus. Thanks Litmus Learning Ltd
How many modules are gcse maths?
Most schools do the modular ( no coursework ) course. Module 1 Module 3 Module 5 These are the only modules remaining as the ones in between were coursework.
Where is light control module in 2005 Grand Marquis?
It is located above the gas pedal ((about 8") under the dash ,3 connectors from engine side plugs into the module ,the module white sticker part number can be read at the back end of module the number usually starts with 5w...............,that is the module.
How long does it take for a lunar module to reach the moon?
3 Days.
How do you change an ignition module on a 1996 LSS?
Remove the 3 coils which are help on by 2 5.5 mm bolts each. The module is now free. Remove electrical connector from ignition module. - Tech JK -----------------------------------
Why does my 1986 ford bronco not start when warm?
Look at the Electronic Control Module. If it is the module type that looks like a dull aluminum box with 2 or 3 plugs to it, these are problematic; Replace it and keep a spare with you at all times.Look at the Electronic Control Module. If it is the module type that looks like a dull aluminum box with 2 or 3 plugs to it, these are problematic; Replace it and keep a spare with you at all times.
How do you get Yellow Bricks on My Lego Network?
Available at Rank 3. Easy to grow in the BFF module, but more available in Club Magazine Module once you get them.
