0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Are you converting from a smaller unit to a larger unit or from a larger unit to a smaller unit?
The answer to that one is going to depend on two things:-- what unit you are converting from-- what unit you are converting to
How is converting a ratio to percent the same as solving a proportion?
Converting a ratio to a percent is not the same as solving a proportion.
Formulae for converting kg into meters?
Kilograms are a unit of weight in the Metric System. Meters are units of distance in the Metric System. There can no more be a formula for converting kilograms to meters then there could be converting pounds into yards.
What is the answer to converting 3.049 into a fraction?
newdiv
Converting 1.5m to feet?
4.92125984 feet ==
How do you install a pto on a autoshift eatonfuller?
Same as you do on a manual transmission... you drain the transmission fluid, remove the PTO cover, and install the hydraulic pump or motor where the PTO cover was.
Are semi trucks with auto shift transmissions more fuel efficient?
The claim is there, but the results are a bit.. inconclusive. It's also a bit biased, largely in part because of the ATA's influence, which also overlooks the fact that the rear end gears of autoshift trucks are at a higher ratio than 'matching' manual shift trucks. For an experienced driver who knows what they're doing with a manual, the difference can be negligible at best. For an inexperienced driver, perhaps they would be, but bad driving habits will impact the fuel mileage of an autoshift truck just the same as it will a manual truck.
Where is filter on 10 speed auto transmission?
There probably isn't one. An autoshift is more the same as a manual 10 speed, with the only difference being an additional computer, and that the shift function and clutch are automated.
Can you convert manual transmission to automatic transmission?
Converting a manual transmission to automatic transmission is not possible but you can replace a manual transmission to an automativ transmission . That is also an expensive deal.
What is meant by framework of IT project?
its a process of converting the manual process to automa tic process
Do coaches have a manual or automatic transmission?
Depending on their GVWR and distances they're expected to travel, they can have either an Allison automatic transmission or an autoshift transmission, which is a twin countershaft manual transmission gearbox with automated shifting and an automated clutch.
Where is the reverse light switch on a peterbuilt?
On models with manual transmissions and transmissions such as the Eaton Autoshift, it's directly on top of the housing for the transmission tail shaft. If it has an Allison transmission, it's done through the transmission computer itself.
Where is the reverse light switch located on a peterbilt 387?
If you have an Eaton Fuller manual or autoshift, it's on the left hand side on top of the transmission... if you have a manual, you undo the screws at the bottom of the boot, lift up the boot, look down there, and you'll see it... there'll be a weatherpack plug connected to it. Disconnect this plug... one pole should be hot with the key switch on. Run a jumper between the two poles... if the reverse lights come on at this point, the switch is bad. If they don't, you have a wiring issue.If you have the ZF Meritor autoshift or an Allison automatic, the reverse lamps are controlled through the transmission computer.
What does one doo with the shifter electrical stuff for converting to manual because of park starter lockout and reverse light and will vtec work?
your question isn't really clear, but i guess your converting a honda from automatic to manual. you will need every single piece from the manual car to make this work, if everything is done right the park starter lockout will be eliminated. what car are you doing this to?
What is the different between a auto shift and a automatic freightliner truck transmission?
The transmissions aren't made by Freightliner, and this answer applies to all commercial truck manufacturers. A fully automatic transmission is clutch free. An autoshift basically adds a synchroniser gear and computer operated shift mechanism to a manual transmission, and still uses a clutch. With an autoshift, poor clutch manipulation often causes the synchroniser gear to go out, making the transmission unable to shift. On a fully automatic transmission, that problem does not exist.
What is auto shift on the proctor silex crock pot?
I think autoshift starts on HIGH for 3 hours, then switches automatically to LOW.
What is an Allison automatic transmission for an commercial vehicle?
Depending on year and model, they can be either mechanically or electronically controlled. They're true automatics - they use a torque converter, unlike an autoshift, which is an automated manual. They're available with 5 - 7 gears for the 1000 - 4000 Series, although they do have a ten speed, twin countershaft transmission.
