answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Could I use a 225-70-16 on my truck on the back and 225-60-16 on the front?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Does a 2wd truck have a track bar?

It could if it has a solid front axle. If it has independent front suspension it would not.


Is a truck driven from the front or diff?

A truck is normally driven from the front.


When passing a large truck do not pull back in front of the the truck until what?

you can see the front of the truck in your rear-view mirror.


When passing a large truck do not pull back in front of the truck until what?

you can see the front of the truck in your rear-view mirror.


Your front wheel locks up on your truck why?

need more information, but it could be a frozen caliper or a collapsed brake line


What is the front of a truck called?

I believe it is called the front or the nose


How do you change the front brakes on a 1991 Toyota pickup truck?

changing front brake pads on 1991 Toyota truck


Is it illegal to drive with a baby in the front sit or a single cab truck?

is it illegal to drive with an infant in the front seat of a truck


When you are passing a large truck you need to make sure you can see a lot of pavement in front of the truck before you pull in back in front of it?

You should see both headlights of the truck in your rearview mirror before you pull in front of it.


What causes your Nissan Frontier front bounce?

Front shocks. You may feel what I could describe as an "UP" bounce feel. If you replace the front shocks this will minimize that feel. However, the Frontier front suspension is quite "bouncy" good truck.


Why does transfer case vibrate front wheels on a 2001 Ford truck?

It could be the U joints from the transfer case causing the problem.


Where is the oil filter located on a 1997 Ford F-150?

There are a few places it could be located... 1. If its a v-6 it would be at the very front of the engine, when you look under the truck it should be right there up front next to the crank pulley. 2. There are two places if it is a v-8 a. It could be in the very front driver side corner of the truck. Right in front of the fender. There is an opening between the front of the fender and the bumper. b. It could also be on the driver side of the engine. If the truck is 4wd then it would be right above the front pumpkin, it may look like an area too small for the filter but it is just big enough. If it isn't 4wd then it would be towards the front of the engine but still on the drivers side. Good Luck