0
0.866xpitch
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How many 8 inches can you cut from a 120 inches?
120/8 = 15
A piece of pipe is 303.4 inches long If five pieces each 41.3 inches long are cut from the pipe how many inches of pipe remain?
A piece of pipe is 303/4 inches long. If five pieces, each 41/3 inches long, are cut from the pipe, how many inches of pipe remain?
Rectangular cards 2 inches by 3 inches are cut from a rectangular sheet 2 feet by 3 feet. What is the greatest number of cards that can be cut from the sheet?
144 cards
Stan cut a wooden plank into 4 pieces. each piece was 18 inches long how long was the plank before Stan cut it?
Roughly 72 inches. The cuts take up space.
A strip of wood is 66 inches long is to be cut into five and half inches pieces how many can be cut?
You can get at most eleven pieces if your saw has any width at all. (5.5 * 12 = 66 but then the kerf (the saw cut width) is not taken into account.
What is thread depth?
It's the depth of the cut from the crest of the surface down to the base on a bolt or screw.
How do you cut female thread?
In general a female thread is cut with a tap. A male thread is cut with a die.
What is the relationship between a nut thread and a screw thread?
when a spiral groove is cut over a hole, then it is nut thread. when a spiral groove is cut over a shaft, then it is screw thread.
When Machining rotors the depth of cut should be no more than 400 inches?
400 inches is a little over 33 feet. .004" is a little more like it.
What is internal thread cutting?
Pitches of thread shall be cut off.
How do you dry crab-apples?
Cut a 36-inch length of thread. Thread your needle and tie a pony bead to the end of the thread. String crab apples until you reach the last 2 inches of thread. Hang each apple string from a hook or drape it over a bar until the fruit wrinkles like a raisin.
Fate who cut the thread of destiny?
atropos.
How do you calculate tonnage of forging press for the part to be forged?
For steel, the formula is (material thickness) x (inches of cut) x 50,000.
How long is the Root depth of cut-flower?
Most cutting flowers are annuals. They have shallow root systems, usually about 4-6 inches. Some common cutting flowers with this root depth are zinnias, button flowers, straw flowers, and statice.
What has a cut going around it that is called a thread?
A screw or a bolt.
What does end off mean in crochet?
In crocheting, to end off means to cut the yarn or crochet thread and tie it so that it cannot unravel. What I usually do is cut the thread for enough for at least five knots. Then I do a single stich, pulling the cut thread through the loop that was on the hook. Then I tie at least two knots.
What depth is a 14 point diamond?
The depth measurement depends on the cut of the diamond, not the carat weight.
