0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the cubic inch when putting a 350 crank into a 400 block?
Standard bore would be 372.
How many meters in 400 meters?
Metres and metres are the same measurement. Therefore, 400 metres is equal to 400 metres.
How many 12x12in tiles does it take to cover 400 square ft?
400 of course !
What three digit number multiplied and added you get the same answer?
200*200=400 200+200=400
Which is larger 40 cm or 400 mm?
They are the same
Does a 351M have the same bell housing as a 429?
Yes it does, as well as the 370, 400, and 460.
Will ford 400 engine fit ford 300 6 cylinder transmission?
The short answer is NO you cu_nt. 400 uses same belhousing pattern as 460, 429, 400 & 351M
What is the difference between a 350 Chevy crank shaft and a 400 crank shaft?
400 has a longer stroke
Is the bell housing the same on a Ford 460 and a Ford 351?
the bell housing bolt pattern is the same but the flywheel on 460 is thicker and makes they pressure plate hit bellhousing from 351m/400 there for it will not work you have to have a bellhousing from a 429 or 460
Is the 400 modified a good motor?
The 351M/400 engines have "thin wall" castings and can not be safely over-bored beyond .040". This is probably the only real drawback.
Can you put big block heads on a 351 modified engine?
the 351m/400 are the same engine the only difference is the crank and the pistons. as far as big block heads u can put 429/460 heads on it but u can put a decent set of 4v 351 Cleveland heads on it and a 4v intake with a 4 barrel carb on there then youll have a real torque monster
Will a c-6 ford transmission off a 400 ford motor fit on a 460 ford motor?
yes,it will also fit a 351m and 429
How do you install a 400 crank into a Chevy 350 engine?
Take the crank to a machine shop and have the main journals turned to accept 350 bearings. Might be a good idea to have it balanced while it's there.
How much oil does a 1973 Pontiac 400 take?
5 quarts total 4 in the crank case and one in the oil filter.
What does it take to put a 400 crank in a 350?
The small block 350 uses a smaller main bearing diameter than the Small block 400. To run a 400 crank in a 350 the crank must be "turned" down at a machine shop to fit the 350 bearing diameters. You also will need to use special pistons with the correct compression height for the 350 IF you are using the 5.7 inch 350 connecting rods. If you use the 5.565 inch 400 connecting rods , then you can use regular 350 pistons. The longer stroke 400 crank also requires that you provide additional clearance inside the block, by grinding notches to eliminate the crank hitting the block and other parts. Finally, the entire engine must be re-balanced to make sure that the engine does not vibrate. The 400 is externally balanced and the 350 is internally balenced so you need to use 400 flywheel and 400 harmonic balancer.
Can you put a big block crank in small block 400?
No
How much will it cost to replace crank shaft sensor 2000 galant?
400 Dollars ..it is located in the same area where the timing chain is..and cover has to come off
