0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What does this mean what side of the street do you come from?
In my youth it meant lower income on my side, and on the other side it meant a high wall and much higher income.
What is an improper fractions?
An improper fraction is one in which the numerator is equal to or larger than the denominator.A normal fraction has the top bit smaller than the lower bit like this:1/2With an improper fraction the top bit is larger than the lower bit like this:3/2an improper fraction is a high number over a lower number like 20-10=2-1* * * * *It is a number where the denominator (bottom) is smaller than the absolute value of the numerator (top).By the earlier definition, -3/2 would not not be an improper fraction because -3 is lower than 2 and so it is not a high number over a lower number.
How high to hang pictures?
Usually, pictures are hung at eye level for viewing, but if hanging in a group some may necessarily be higher than eye level while others may be lower than eye level.
Cetane number equals Diesel Index - 3?
Cetane number is derived from an engine test. It measures the ignition characteristics of diesel fuel, (which detonates under pressure). The higher the Cetane number, the greater the resistance to pre-ignition. A high cetane diesel can be used in high compression (more effcient) engines. Diesel Index (DI) is a calculation allowing an approximation of Cetane No., when there is no Cetane Test Engine available. The DI is derived from the Analine Point. The Analine Point is a temperature, where analine and the (diesel) sample become completely miscible. DIESEL INDEX = ((ANILINE POINT(DEG F))(API GRAVITY))/100 A higher aniline point (and therefore a lower aromatic content) in diesel oil is desirable, in order to prevent autoignition in diesel engines.
Is a low or high IQ better?
The higher the IQ, the higher the Intelligence Quotient. The scale starts at 10 and can go higher than 200.
How depletion region become narrow?
In fabrication process low resistivity (ohm/cm) of material results to expansion of depletion region lower than high resistivity
Do wires that have high resistivity have high conductivity also?
No. In fact it is the opposite. Conductivity is the reciprocal of resistivity so a high resistivity means low conductivity. peace.
What is a high resistance circuit?
AnswerThe resistance of a material depends on its length, cross-sectional area, and resistivity. This is expressed by the following equation:resistance = [(resistivity x length) / cross-sectional area]So, resistance is directly-proportional to the resistivity and length of the material, and inversely-proportional to its cross-sectional area. So a high resistance can be obtained by increasing the length of the material or by decreasing its cross-sectional area, or by choosing a material with a high resistivity.It's also worth pointing out that resistivity is affected by temperature. For pure metals, the higher the temperature, the higher the resistivity, so the higher the resisistance. For example, a hot (i.e. an operating) tungsten lamp will have a much higher resistance than a cold tungsten lamp.
Why sheet steel with high silicon content is used in transformer core whereas lower silicon content sheet for rotating machine?
high permeability ,low hysterisis,increased resistivity
Does alumina become conductive at high temperatures?
Alumina is a good electrical insulator; at high temperatures the resistivity is smaller than the resistivity at room temperature.
Is it better to have a high or low mean absolute deviation?
Lower
Does the piccolo have a high or lower sound then a flute?
Higher.
How high resistivity possible for nickel ferrite?
By following the wet chemical route the size of the particle would be obtained in the nano range and further due to large number of small grain boundaries with large number of grain boundaries the electrical resistivity gets increased.
Is resistivity of a good conductor high or low?
It is Low
Which of these statements is falseA lower-pitched sound is produced when the vocal cords are relaxed.A lower-pitched sound has a higher frequency than a high-pitched sound.Stretching the vocal cords produces a high-pitched sound?
A lower-pitched sound has a higher frequency than a high-pitched sound.
Why is the resistivity of a potentiometer high?
Because you touch yourself at night.
Normal range for diastolic and systolic blood preassure diastolic 110 for systolic 71?
The systolic number is always higher than the diastolic number. 120 or lower for systolic number and 80 or lower for diastolic is in normal range. If diastolic is high, say 95 after running - is ita high? and if what should one do?
