no, it has to be in the ABC
Yes, there is a problem with water coming out of the PVC pipe on the side of the house.
well if you take long pieces of PVC and plant one end deep in the ground and bend it to an arch shape and plant that end in the ground you have a start. Then you do about six more in a row side by side. make shure their planted tight. Then you can stretch some heavy duty plastic over the PVC and secure it with straps.this is only a very rought draft on how to make a green house so you might want to Google it to get different ways. But it is a lot easyer to buy one.
No, it is generally not necessary to break the ground wire at a pull box and bond it to the box. The ground wire should instead be continuous and connected securely to ensure proper grounding throughout the electrical system.
The PVC wire fill chart provides information on the maximum number and size of wires that can be safely installed in a PVC conduit based on the conduit size and type of wire being used.
The wire fill chart for PVC provides information on the maximum number and size of wires that can be safely installed in a PVC conduit based on the conduit size.
No bell wire is not meant to be 230V.
PVC conduit is recommended for underground installations. Just remember that a ground wire equal to the maximum load current of the device connected at the other end has to be installed. This ground wire is not counted in conduit fill calculations. It has to have a green insulation in colour and be of a continuous length.
The problem sounds like the water pipe is not bonded to the ground wire of the distribution. These two wires should have a potential of zero between them once they are bonded together as per electrical code recommendations.This must be an older installation as nowadays most new water pipe installations use PVC to service a water supply to the home. In this case the PVC water supply pipe does not need to be bonded to the ground wire of the distribution service.
The recommended PVC conduit size for accommodating a 6-3 wire is 1 inch.
No, an equipment grounding conductor is not required in PVC conduit because PVC is non-conductive and does not provide a path for electrical fault currents to flow. However, it may still be required by code depending on the specific application and local regulations. It's always best to consult with a qualified electrician or local building code official for guidance.
false
Pic pipe under ground