answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Explain the use of marking out conventions (such as datum edgeslines centre lines?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is double marking and when is it used in netball?

Double marking is when two people are marking one person. It may happen on a centre pass. The centre without the ball may go and mark GA or WA because this is the popular position to throw it too.


What does a punch do in construction tools?

A punch is for making holes or marking a spot to centre a drill bit.


How do you divide a circle in 10 pieces?

By marking out 10 arcs of 36 degrees around its circumference and joining them to the centre of the circle.


How do you defend goal attack and center at the same time?

You dont.I goal attack should have a Goal Defence defending them & the Centre should have the other Centre defending them. Each position has some one marking them


What is the address of my ssc board center no 2271?

The address of your SSC Board centre cannot be revealed at the moment because it is used for the marking purposes.


Which player is responsible for marking the Goal Attack in netball?

The goal attack is marked by the goal defence. Goal Shooter-Goal Keeper Goal Attack-Goal Defence Wing Attack-Wing Defence Centre-Centre


Where is the most likely place to find a dalek?

In the Whoniverse (DW-universe) Skaro.In real life I would be the BBC television centre, Cardiff (where Doctor Who is filmed) and Doctor Who conventions.


Explain why the centre of gravity of a double decker bus is quite low?

It is designed low so that the bus can't fall over.


What first appeared on roads in slough in 1956?

Cat's Eyes. Common name for raised refective road marking prisms running down the centre of the road for use in night driving. Introduced in the UK in 1956.


What is the difference between a center punch and a dot punch?

The centre punch is made form mild steel with the point hardened and tempered so that it withstands impact with the material it is marking. It is normally used to mark the centre of a hole to be drilled either by hand or on the drilling machine. The dot punch is a lighter and thinner version of the centre punch and is used basically for the same job. However, it is more accurately as the dot produced is smaller.


Are there any anime conventions in Georgia this year and when?

Anime Weekend Atlanta (AWA) : the AWA will be held September 30th - October 2nd, 2011, at the Renaissance Waverly Hotel and Cobb Galleria Centre in Atlanta, Georgia . ~ See related link below .


How would you turn away a caller who the law centre is unable to assist?

Apologise then explain that the law centre cannot help with their enquiry, in a positive and apologetic tone. If possible, give the caller some advice on who to call for their enquiry, or pass them onto that particular department.