Answer #1:
Formula of pressure is:-
P=hdg, where h stands for depth of the container d the density of the liquid and g is the acceleration of gravity.
===============================
Answer #2:
It has not escaped my notice that you asked for the pressure at the bottom of a jug with the radius that we'll call 'R' and the weight in the jug that we'll call 'W'.
Pressure = (force) / (area) .
Force = W
Area = (pi) R-squared.
Pressure = W / (pi) x (R-squared)
you find the radius of a cone by the bottom of it or the round part
If it has a mass of 72 kg, then its weight on earth is 705.6 newtons (about 158.7 pounds). Its size, shape, color, fabric, contents, or the pressure it exerts on the ground don't matter. Consider this: If you set the suitcase down on its bottom, on one side, or on one end, its pressure on the ground would be different in each case, but its weight would not change.
By calculating the areas of the rectangular bottom part, (LxW) , and then using pi to find the area of the top rounded part. (3.14 x Radius x Radius divided by 2) - if the rounded section is half a circle
You need to know if the sphere is solid or hollow. You also need the "density" in terms of pounds weight per unit volume. Then Volume = Mass/Density And Radius = cuberoot[3*Vol/(4*pi)]
Divide the circumference by 2PI to find the radius. ( C = 2PI*Radius)
you double the radius to find the diameter.
Highest pressure readings would be found at the bottom of the water column. The densest waters are typically found at the bottom as well, due to the weight of the overlying water. The warmest temperatures are usually found near the surface where sunlight can penetrate and heat the water.
The formula to find pressure is given by the equation ( P = \frac{F}{A} ), where ( P ) represents pressure, ( F ) is the weight (or force) applied, and ( A ) is the area over which the force is distributed. Pressure is measured in units such as pascals (Pa) in the SI system. Essentially, pressure increases with greater force or decreases with a larger area.
You already know the radius.
squares do not have a radius
A kite does not have a radius.
You can't. In addition to the cylinder's diameter, the pressure at its base also depends on the density and depth of the fluid in the cylinder ... which gives you the weight of fluid resting on the base area. The pressure alone is not enough information to allow you to calculate the diameter.