Speaker wattage is a measure of the power handling capability of the speaker. This assumes a clean un-clipped signal from the amp. The spec you need is Sensitivity: Sound Pressure Level (in db) with 1 watt input of a 1khz signal measured at distance of 1 meter from the speaker. Highly efficient speakers are going to be around 96/98 db.
If your speaker is rated at 93 db 1watt/1meter, then it will take twice as much amplifier power to run it up to 96 db.
Depending on whether you want your ears to bleed, most speakers will do quite well with 100 watt or so high quality amplifiers. Keep in mind, if you want extreme volumes get a 200/300 watt amp or better to give you the headroom needed to keep signals from clipping and blowing your speakers.
This answer assumes the question was for home stereo.
How big are the halls you're playing? 100 watts is good for a small hall.
If you are using typical residential voltages ( 120v/240v) a 40 amp breaker is plenty big enough. You could even use a twenty amp breaker.
650 sq ft equals 60 m2.It is a modet apartment.
If the overcurrent protection device is 40 Amps, then a 30-Amp plug can overheat and catch fire at 40 Amps before the circuit-breaker blows.
yes bailed 40 round bales with bailer hook up to a 10 amp circuit
With 600 watts, you can't really go too big, and if you only have one amp, you can't go with separate mids/highs and a sub, so personally, I would try to find a pair of 200 watt speakers that have nice tweeters, mids, and lows, all in one. Don't go for anything over 200 watts each, because you want to leave room on your amp. You don't want to get two 300 watt speakers, because your amp will be working at full power, which isn't good for it or your new speakers. So all in all, a nice pair of 200 watt full range speakers is what I would be looking for.
a watt is power, or 1 joules sec= 1 watt an amp is 6.242 × 1018 electrons passing a given point each second,
RMS is the max watts its recommended to run on, for example i got 2 15's that are 3000 watt rms so i got a 2500 watt amp. You don't want to get too big of an amp because it will put stress on the speakers and wont last long.
How big are the halls you're playing? 100 watts is good for a small hall.
Depends on the amp. There are two different types. Theres one for your in car speakers and theres one for your sub. The small amps are to increase sound for the small speakers and the big amps are so you can have subwoofers and you can have lots of bass.
Depends on what your willing to spend.. For two 1200 watt subs I would go with a 1200 watt amp and run both of then 600 watts ( you don't want to always run subs to full power, because the voice coil might blow or you will light your subs on fire). If your feeling brave you can run a 2000 watt amp 0_o that will annoy your neighbours, but make your car bump!
1000W will be suitable. See the specifications of speaker.
A 30 amp breaker wired with AWG #10 wire.
If you are using typical residential voltages ( 120v/240v) a 40 amp breaker is plenty big enough. You could even use a twenty amp breaker.
Yes most of you big name amp's have a high power input that comes with amp it's the flat plug that goes in the side. Just wire it to the speaker leads from headunit then wire up speakers to amp.
the same way big speakers work
deffinatley two or one big one, my friend has two fifteen inch kicker L7's and he is pushin them with a 2600 watt amp they are rated at 1000 wats rms it depends on the size