Not if it's functioning properly.
The purpose of a circuit breaker is to shut off power if the circuit exceeds the rated power capacity of the wires.
Don't plan to exceed the 30 Amp capacity of your house wiring; the results will be destructive.
A 50 amp breaker is an overcurent device.
Not legally because the rating of the 30 amp receptacle would have a 50 amp breaker ahead of it. If you reduced the feed breaker to 30 amps and still use the #6 wire, this would be within the electrical code rules.
The recommended type of breaker to use for a hot tub that requires a 50 amp GFCI breaker for safety is a 50 amp GFCI breaker.
No there are no adapters made for these types of installations. The reason there are no adapters is to provide a factor of safety. To plug a 30 amp plug into a 50 amp receptacle could allow 50 amps to be applied to a 30 amp rated cord. The 50 amp receptacle is more than likely being fed by a 40 amp breaker. Just change the plug cord to match the ampacity of the breaker ahead of the 50 amp receptacle. Or change the 50 amp receptacle and 40 amp breaker to a 30 amp breaker and use your existing cord plug.
For a 50 amp hot tub installation, a double-pole 50 amp breaker is required.
50 watt equals less than 1/2 amp current flow at 120 volts so you can have 30 light on a 15amp breaker or 40 on a twenty amp breaker.
No, a double pole 50 amp breaker protects a 240 volt supply at 50 amps. The number that is on the handle of the breaker is the amperage that the breaker will trip at if an overload occurs on the circuit.
The maximum amperage capacity of a 50 amp Pushmatic breaker is 50 amps.
The maximum amperage capacity of a 50 amp breaker panel is 50 amps.
A 50 amp breaker can handle a maximum current capacity of 50 amps.
Yes as long as you change the 50 amp breaker to a 15 amp breaker. You will be hard pressed to get the 50 amp #6 wire under the terminals of the 15 amp receptacle.
For a 240-volt circuit that requires a 50 amp breaker, the appropriate size of the breaker needed is 50 amps.