The people did not change. There was a brief period when there was some confusion, and there may have been some profiteering during the transition but nearly everyone came through unscathed. Even countries with poor educational achievement succeeded in the transition. Only the US (along with some minor countries), somehow, is incapable of the switch.
English and Metric
Celsius (Fahrenheit for Imperial measurements)
The International Table Tennis Federation (ITTF) started in 1926 and the Laws of Table Tennis included all measurements in imperial units only (feet and inches). In 1937, the metric (metres, centimetres & millimetres) equivalent were added alongside the imperial measurements. In 1947, the metric measurements were made the primary units of measurement with imperial measurements secondary. In 1975 the imperial measurements were omitted from the Laws completely and all measurements were stated in metric units only. So table tennis tables are defined in the Laws of Table Tennis using metric measurements only. An official table tennis table is 2.74m long, 1.525m wide and 76cm high, and the net is 1.83m long and 15.25cm high
In imperial measurements the 'long ton' or 'UK ton' is 2240lbs (pounds) or, in metric 1,016.0469088 kg (kilograms). The 'short ton' is 2000lbs The metric 'tonne' is 1000kg which equates to about 2205lbs
No, a foot is not a metric measurement. Metric measurements of length would include millimeter, centimeter, meter, and kilometer.
English and Metric
Hundreds.
0.65237 by 3.57
That would be metric and Imperial.
Imperial measurements are based on multiples of various numbers eg 16 ozs in a pound, 14 pounds in a stone etc. Metric measurements are based on multiples of 10 eg 1000 grams in a kilogram etc. This makes Metric measurements easier to use in calculations.
Either metres (in metric) or miles (in imperial).
two units of measurements are MKS and CGS systems
England uses both metric and imperial measurements interchangeably. Retailers are required by law to use metric measurements, but they are allowed to quote both.
no-one
A few key points about the change in Australia from imperial to metric measurements (not counting the introduction of decimal currency):Imperial pints and other forms of imperial measurements were phased out in Australia between 1972 and 1979.In October 1977, at a conference of Commonwealth and State Ministers, it was agreed to enact legislation which stated that no contracts written up using any non-metric units would be legal.By May 1979, most retail sales were done in metric, meaning bottles had to be sold in litres and mL rather than pints. Advertising still tended to use some imperial measurements, but that was gradually phased out as people became more familiar with litres and mL.
Celsius (Fahrenheit for Imperial measurements)
The International Table Tennis Federation (ITTF) started in 1926 and the Laws of Table Tennis included all measurements in imperial units only (feet and inches). In 1937, the metric (metres, centimetres & millimetres) equivalent were added alongside the imperial measurements. In 1947, the metric measurements were made the primary units of measurement with imperial measurements secondary. In 1975 the imperial measurements were omitted from the Laws completely and all measurements were stated in metric units only. So table tennis tables are defined in the Laws of Table Tennis using metric measurements only. An official table tennis table is 2.74m long, 1.525m wide and 76cm high, and the net is 1.83m long and 15.25cm high