You can't. If you did do it as safely as possible, it still would not be UL listed for cord-and-plug use (which is exactly what you would be doing). In short, if your home burned down due to this contraption, your insurance would not pay anything because you did not use UL approved electrical fixtures. Many people do not know this and see such ideas on HGTV shows and the like. What the shows don't tell you is the consequences, and probably because they don't know what they are. I've never seen a professional electrician suggest making your own light fixture. It's usually an interior designer or similar.
a socket that is soldered to a printed circuit board, into which a 8 pin integrated circuit package may be plugged to connect it to the circuitry.
A 14 gauge extension cord can safely carry 15 amps, but not very far. Number 14 gauge extension cords are only rated for about 13 amps according to the labels on the cord. This is because the insulation is not intended to withstand the heat of currents above this level. Running this cord over 50 feet or loading it to 18 amps would be unacceptable.The likelihood of the cord maintaining the 18 amps for any amount of time for the high current to do any damage to the insulation of the cord is not very great. Extension cords are only an extension of the 15 amp wall circuit that they are plugged into. On overloading the extension cord by that amount the overload will trip the 15 amp supply breaker. An example of this is jamming a circular handsaw when it is plugged into the end of a 50 foot extension cord. The next action that is taken is to reset the tripped breaker.
circuit diagram is the most important in electric stove plugged into the socket
If the ballast of the HPS fixture has a 120 volt tap then, yes it can be plugged into a 120 volt receptacle.
None
Yes, it safe to touch a extension cord while its plugged in.
You should know the maximum current drawn from the distribution box (in amps) and that must be less than the current that the extension cord is able to supply.
If there is no load plugged into the cord there will be no power consumed. The only time the resistance of the cord will come into effect is when the circuit becomes energized through the load plugged into the end of the cord.
A 15 Amp extension cord can be plugged into a 20 Amp circuit. It is important that what you're extending does not require more then 10-12 Amps.
Well if the lights were outdoor Christmas lights that shouldn't happen. Although if one of the wires connecting to the lights was damaged in some way, then all the lights would most probably fail to work.
Outdoor fountains are typically hooked up to water mains and don't need to be plugged into a hose.
yes
There are several parts to an extension cord. There is the "female" end where you would plug in the appliance, the cord, and then the "male" end which gets plugged into an outlet.
Yes, you can put the iPod Touch wall charger into an extension cord. That extension cord has to be plugged into a wall to be able to charge the iPod, though.
press Connect on the controller then FC1 on the receiver and it will connect (providing u have plugged the receiver in and turned your ps2 on
get a new one:)
There is outdoor lighting for balconies that provides serene and comfortable lights. Porch lights can be purchased from Home Depot, Lowe's , and Ace Hardware. Some outdoor lightening is solar powered and wireless. Others can be routed to an outlet and plugged in for your convenience.