Length x width x depth in inches. Then x .00625 = tons
Asphalt density is calculated by dividing the mass of the asphalt by its volume. To determine the mass, you can weigh a sample of the asphalt mixture, and for volume, you can use the formula for volume based on the dimensions of the sample or by water displacement. The density is typically expressed in pounds per cubic foot (lb/ft³) or kilograms per cubic meter (kg/m³). It's important to ensure the sample is representative of the entire batch for accurate results.
ASPHALT
To calculate the weight of asphalt in a square meter that is 50 mm thick, first convert the thickness to meters (0.05 m). The density of asphalt typically ranges from 2,200 to 2,500 kg/m³. Using an average density of 2,400 kg/m³, the weight of asphalt would be approximately 120 kg per square meter. This is equivalent to 0.12 tons per square meter at that thickness.
Carpenters geometry to calculate angles of roofs and gables, as well as adding and multiplication when making measurements and ordering material.
Any number that you like: it depends how high the asphalt is stacked!
2.23 tons
hst
Calculate the volume of mix needed by multiplying 20x20x9. This gives cubic inches. Then divide that answer by 144 cubic inches per cubic foot, and you have the volume in cubic feet. A cubic foot of asphalt is a different weight depending on the weight of the rock in contains, but let's 158 pound of asphalt hotmix per cubic foot. Multiply the volume in cubic feet, above, by 158lbs, and you have the weight of mix per 20x20x9. Divide the answer by 2000 to convert to tons. Divide the tonnage by the weight per cubic feet calculated above in the second paragraph.
you can calculate like this:length*wideth*height*density.If you need more information, pls contact me: mould@sinomould.com
i dont know this nswer
you have to times it by 1000000000000000 and then divide be 15 then times it by 2
tonnage capacity is equal to area x shear strength of material. calculate area by multipying length and thickness of material.
To calculate casting machine tonnage, you need to consider the maximum pressure that the machine can exert and the area of the die or mold. The formula is: Tonnage = Pressure (in tons per square inch) × Area (in square inches). Ensure that the pressure is appropriate for the material being cast and that the area corresponds to the surface where the pressure is applied. It's essential to factor in safety margins and the specific requirements of the casting process.
1+1=2 2+2=4 3+3=hello i like tomatos
tonnage capacity is equal to area x shear strength of material. calculate area by multipying length and thickness of material.
what is the burthen tonnage
For steel, the formula is (material thickness) x (inches of cut) x 50,000.