0
There are many types of ballasts in the electrical industry. To get an answe, the type of ballast must be stated.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
I've changed the bulbs in a 40 inch fluorescent light fixture but it still goes out. What might be wrong?
It sounds like your ballast is malfunctioning. If it is a magnetic ballast it will probably have tar protruding out of it and the ballast will be very hot. Buy a new electronic ballast. Change the wiring to the end sockets like it is shown on the electronic ballast print that can be found on its label. You will need new tubes for the new ballast. Diameter will be T-8.
Where is the ballast resistor on a 2000 Chrysler Sebring convertible?
It does not have a ballast resistor.It does not have a ballast resistor.
How to connect ballast?
Ballast connection diagrams are on the identification label that is on the ballast.
Can a dimmer switch be added on any light?
only regular lights like in ur house if u want to dimm a fluorescent light u have to change out the ballast to a dimmable ballast
Where is the ballast resistor for a 1994 Jeep Cherokee?
It does not have an ignition ballast resistor.It does not have an ignition ballast resistor.
How do you wire 347 volts ballast to 110 volt feed?
You don't. A ballast with a 347 volt input is a commercial ballast. The 347 volts comes from a 600 volt three phase four wire Y system. You can change the ballast out to a 120 volt and rewire the unit but in most cases it is cheaper to buy a completely new lighting fixture.
What is the function of the ballast tanks on a submarine?
To change the buoyancy of the boat and allow it to rise and sink in the water.
What changes take place in the ballast tanks when a submarine that has been under water rises to the surface?
The change that takes place in the ballast tank is the chief of the boat flips a switch and pumps the water out of them.
Ballast smells burnt what to do?
A ballast that smells burnt is going bad. The ballast will have to be replaced to fix the problem.
How does a submarine change its density?
To be able to submerge in the water, the sub has to become heavier. Ballast tanks are utilzed for this purpose. Water is let into them, and the sub sinks. To rise, air is pumped into the ballast tanks, and the sub rises.
How do you replace ac ballast where emergency ballast present?
First you need to determine if it's the ballast that's bad or the emergency ballast. The emergency ballast can go bad and cause the bulbs not to work or not all of them to work depending on the lights wiring setup. Push the test button on the emergency ballast which should have a red glowing indicator light. If all the lights illuminate slightly, change the emergency ballast. It's best to buy the exact ballast for this repair. i.e. If it's a T8 3 lamp fixture. Buy a T8 3 lamp ballast not a 4. You can use a 4 in place of a 3 lamp, but the 3 lamp will be more user friendly. Easiest way is to note what wires go to what. Draw a diagram if you have to and just simply match them back up.
What is a good sentence for the word ballast?
A good sentence for the word ballast is.......The ballast is not heavy enough and the boat is about to sink.
