Yes an adapter can be made. You must keep in mind that the US generator's speed is set for 60 Hz generation. The frequency of a generator is governed by the RPM of the engine. If the generator has speed control on it, it will have to be turned down so that the frequency meter reads 50 Hz.
Like any other switch: you fasten a pigtail to the screw terminal and use wire nuts to connect all other wires to the other end of the pigtail. Why you would ever want to do that in a 3-way would be a head-scratcher for a different question.
US NEC: You must provide a box to join the old and new wiring together. Also, when making modifications to old wiring, you must upgrade the old wiring as needed to meet current code.
Tie all the white wires together under a wire nut and push them back in the box. Tie the black incoming power wire and outgoing power wire, if there is one, together under a wire nut with a black wire pigtail. Connect this pigtail to one screw on each light switch. Connect the black wire going up to the lights to the appropriate switch you wish to use to control that light.
Answer for USA, Canada and countries running a 60 Hz supply service.There are no dangers to using a pigtail surge protector. The installation of the protector must be done correctly though. The pigtails must not be installed on an existing circuit that has an existing load on it unless the breaker is approved for more than one circuit load on it. The protector must use a new two pole breaker with no additional load on it except the surge protector. This is the correct procedure to connect a pigtail surge protector to a distribution panel board.
Just firmly connect the wires under the screws and that will couple them. Each outlet has two hot and two neutral screws; just connect the wires appropriately and make certain that the outlet is properly grounded.
Pigtail is a device to protect the brush from sparking
Her hair had a pigtail at the back.
Like any other switch: you fasten a pigtail to the screw terminal and use wire nuts to connect all other wires to the other end of the pigtail. Why you would ever want to do that in a 3-way would be a head-scratcher for a different question.
The Clue of the Pigtail - 1923 is rated/received certificates of: UK:A
Yes, "pigtail" is a compound word made up of "pig" and "tail."
The Pigtail of Ah Lee Ben Loo was created in 1928.
US NEC: You must provide a box to join the old and new wiring together. Also, when making modifications to old wiring, you must upgrade the old wiring as needed to meet current code.
Tie all the white wires together under a wire nut and push them back in the box. Tie the black incoming power wire and outgoing power wire, if there is one, together under a wire nut with a black wire pigtail. Connect this pigtail to one screw on each light switch. Connect the black wire going up to the lights to the appropriate switch you wish to use to control that light.
pigtail brades
Answer for USA, Canada and countries running a 60 Hz supply service.There are no dangers to using a pigtail surge protector. The installation of the protector must be done correctly though. The pigtails must not be installed on an existing circuit that has an existing load on it unless the breaker is approved for more than one circuit load on it. The protector must use a new two pole breaker with no additional load on it except the surge protector. This is the correct procedure to connect a pigtail surge protector to a distribution panel board.
Check pigtail connection at alternator (possible loose), or voltage regulator going out in alternator, take to autozone or other and have tested, replace.
How do you wire a Pigtail for a Fuel Pump on a 97 Chevy Blazer Thank You EVa