The neatest way of doing it is to take the wire across the attic side of the ceiling. If there is a floor above, then there is a bit of carpentry involved. Determine which way the ceiling joists run and open a hole between them and fish the wire to the new location where it is needed. There is also in the market place a product called Wiremold. It is a surface conduit system.
See Sources and related links below;
A jumper wire should use to bridge electrical ground across?
No, you can feed it with a 2 wire Romex + ground. It depends on what is mounted on the ceiling. If it is just a light all you need is 2 wire + ground Romex. However if it is a fan/light and you want to control each one independant of the other you will need to use 3 wire Romex + ground. This is of course if you have 2 seperate switches. You would then connect the red wire to the blue light wire and the black wire to the black fan wire. If you use 2 wire Romex just connect the blue and black fan/light wire to the black wire in the ceiling box.
The neutral wire will have writing or ribs on it and connects to the white wire. The smooth wire is hot and connects to the black wire. Use 3 strand wire in size AWG # 16. If the fan has a light it will have a blue wire. Connect that blue wire to the black wire.
the hot wire carries the electrical voltage
The rotor turns (rotates) causing magnetic fields to move across a coil of wire. This induces an electrical current in the wires of the coil.
Wire nuts
A jumper wire should use to bridge electrical ground across?
There is not enough information to answer this question.
An electrical generator does that.
yes
No, you can feed it with a 2 wire Romex + ground. It depends on what is mounted on the ceiling. If it is just a light all you need is 2 wire + ground Romex. However if it is a fan/light and you want to control each one independant of the other you will need to use 3 wire Romex + ground. This is of course if you have 2 seperate switches. You would then connect the red wire to the blue light wire and the black wire to the black fan wire. If you use 2 wire Romex just connect the blue and black fan/light wire to the black wire in the ceiling box.
no sparking fanThe white wire from the fan to the white wire from the ceiling get wire nutted together.The black and blue wire from the fan go to the black wire from the ceiling and all 3 get wire nutted together. Lastly the green wire from the fan and the bare copper wire from the ceiling get wire nutted together. 90% of fans are wired this way.
Alexander Grahm Bell
I resistor is called so because it provides electrical resistance (measured in ohms). Electrical resistance describes how an electrical conductor (a wire) opposes the flow of an electrical current (flow of electrons). To overcome this opposition a voltage (a energy) must dropped (used) across the conductor (wire).
Just change the switch, The type of wire has no bearing. The insulation will be brittle. If needed wrap the ends in the box with electrical tape. Only other solution is replacing the wire which means ripping out the wall and ceiling to get to the wire.
I have a Hunter ceiling fan that is operate's by remote only, I have a red wire coming out of the ceiling where do I hook that wire ?
The electrical terminology of a wire with no insulation on it is a bare wire.