Simply run a wire from that outlet to that wall switch. Be sure you use the exact same wire size that you find in that outlet. It will be AWG 12/2 or 14/2. Do not mixes wire sizes. Connect the ground to green ground screw at outlet, and white wire to silver screw, and black wire to gold screw. At the light switch connect all white wires together under a wire nut and push them back into the box. Connect the ground wire to the green ground screw on the switch. Now connect the 2 black wires you have left, power in and power out, to the 2 screws on the switch. Does not matter which wires you connect to the 2 screws.
Could be a loose connection somewhere, or a bad switch, or a bad outlet.
Yes, just make sure it is a 220 volt switch.
Home depot sells RF switches whereby if the fan is connected to the transmitter. It can be controlled by as far as 5 meters i believe In my SPA i have this device for safety. switch here get turn on there
The child must have got electrocuted if the outlet switch was on. As a precaution, keep such outlet covered so that the child can not insert the finger into the outlet.
You can if you have a neutral wire present. If the existing switch is what is called a "switch loop" then you can not change the existing switch to a switched outlet. You can identify a switch loop by looking at the wires coming into the switch bow. If there are only one set of wires usually a black and white and they go directly to the switch then you have a switch loop
If there is a black wire going from the outlet to the switch and the other side of the switch goes back to the outlet then just cut these wires and connect supply wire directly to outlet. If the supply goes to the switch first, disconnect from switch and connect the two wires with a wire-nut. Some situations only switch one of the two outlets in a duplex device. Do the same thing, but also replace the outlet since the strapping between both outlets has been removed.
No, that is not unsafe.
Could be a loose connection somewhere, or a bad switch, or a bad outlet.
You've got to use a test light to see if there is electricity getting to the switch. First check to see if it's getting past the fuse - then to the switch with the switch off - then through the switch with the switch on - finally to the blower motor.
ask them how
On what? IS this an outlet or a switch?
You need to run a wire from the existing power source to switch to switch to switch to outlet.
No as the circuit is broken so no electricity can flow through the ciircuit . <<>> Most small appliances these days have switches on them. The voltage potential is at the kettle but stops at the switch. As soon as the switch is turned on, the circuit is completed and the appliance operated. In the UK there is a switch combined with the receptacle. This switch is used to disconnect the voltage output to any device that is plugged into the outlet.
yes
Yes, just make sure it is a 220 volt switch.
Plug a lamp into a working socket of an outlet to ensure the lamp works. Then turn off the switch and plug lamp into all outlet sockets, top and bottom outlets until the lamp doesn't light. Then turn on the switch and the lamp should light. Often a switch in a bedroom is only connected to one socket in a duplex outlet. It is possible to remove a jumper in an outlet to isolate the sockets for just this purpose. Often an electrician will install the outlet upside down (The third prong pointing up, to identify the outlet.
A single pole switch controls a light or outlet at one location. A 3 way switch controls a light or outlet from 2 locations.