I'm guessing you want to know what a 240v switch is? If you look at a 120v single pole switch, you will see two brass screws on one side. This type of switch is designed to interrupt current flow in one conductor. A 240v switch is really a double pole switch. It has 4 screws and is capable (and required) of interrupting current flow in two conductors simultaneously. This is an NEC requirement. It allows a local means of disconnect instead of having to go back to the breaker, and a multiwire disconnect is required to disconnect all ungrounded (hot) conductors at the same time. That way one 120v leg cannot be shut off while the other is on. IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS. If you do this work yourself, always turn off the power at the breaker box/fuse panel BEFORE you attempt to do any work AND always use a meter or voltage indicator
to insure the circuit is, in fact, de-energized.
No, the receptacle's rating is 240 volt and that is the maximum voltage allow to be applied to that device. To prevent this condition from happening 277 volt receptacles and switches have a larger box that they fit into. The retaining screws are set apart further that a 240 volt device which makes it impossible to install a 240 volt device in a 277 volt junction box.
2304w
The question is "use less of what?". If they are both the same wattage the 240 V light will use 1/2 the current of a 120 V light.
No. To prevent this sort of thing from happening, the 277 volt device and receptacle is physically larger that a 240 volt receptacle and will not fit in a regular receptacle junction box. For a 277 volt system the proper size junction boxes have to be purchased.
Remove the light sensor and place a switch between the red and black wires. The black wire is one leg of the "hot" pair and the load is connected to the red wire. This will now switch the black hot through the red wire that goes to the load.
Use a DPST - A two pole switch.
Unless the switch has a pilot light on it there is need for a neutral connection to the switch.
If you mean 110/240, yes, but there may be a hidden switch to switch it to 240 volt mode. Check the manual.
No, the receptacle's rating is 240 volt and that is the maximum voltage allow to be applied to that device. To prevent this condition from happening 277 volt receptacles and switches have a larger box that they fit into. The retaining screws are set apart further that a 240 volt device which makes it impossible to install a 240 volt device in a 277 volt junction box.
No, the voltage rating of the switch is too low.
Yes, you can easily use it. Just install it as you would any other 120 volt light fixture and change the bulb from a 240 volt bulb to a 120 volt bulb. It will work just fine.
The conscience is no. There is a work about by using an intermediary relay coil rated at 120 volts to switch the 240 volt feeder line.
2304w
The question is "use less of what?". If they are both the same wattage the 240 V light will use 1/2 the current of a 120 V light.
No, but if you ever switch to an electric stove you will have problems getting a 240 volt circuit to that location. I would go ahead and install a 240 volt outlet at that location if this is new construction. Costs very little and you will be all set for the future.
No. Not safe to do so. The distances between contacts may not be sufficient.
the plastic part of the light switch should never show voltage especially if it's a 120 volt circuit. 240 volts is two 120 volt circuits the circuit might be connected to another circuit in the bathroom separating them will fix the voltage but you should also inspect and replace the switch. Chris Belveal