0
You need to put the #1 cylinder on top dead centre, either by lining that dot on the tooth of the cam belt gear up with the indent on the oil pump which is about 2cm from the right, or by lining up the main pully with the marks on the lower cam belt cover. the timing marks for the head are on the backing plate behind the cams, on the exhaust its on the rop right its a mark you cant miss, and on the left its to the left of the cam, close to being inline with the cam. the valves should be tuned 2 where the pistons are so you wont do any damage installing it. put the head gasket on, then sit the head on the engine on the block and line it up with the dowls and it will sit nicely on. the indents on the cams should be facing the correct way to get the head bolts in the head. dont forget the washers and oil up the bolts before you torque them down. and once the main bolts are on, dont forget the 3X10mm bolts on 3 of the corners of the engine, they may be small but u can blow the head gasket of they aren't on. you cant get a torque wrench on them so just do them up tight, but not over tight.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you install cylinder head bolts on a 1996 Saturn?
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
Installing cylinder head temperature sensor on f-250?
To install a cylinder head temperature sensor on a F-250, you disconnect the cylinder head sensor from the electrical connector at the rear of the cylinder head. When installing the new one, you reverse the process of removal. The cylinder head temperature sensor is located by the O2 sensor.
What diesel engine has no cylinder head?
A short block. A long block is a complete engine ready to install.
What are the cyl. head bolt torque specs for a KIA 1.8 L 2000?
Hello: Install cylinder head bolts. Tighten cylinder head bolts according to following procedure: Tighten cylinder head bolts in order shown, Can not show diagram for this. Tightening torque : 36.1 lb-ft (49N
What exactly is the thing called RB20DET?
If something is called an RB20DET that means it is an engine developed by Nissan. It was produced from 1985 to 2004 and was build in the Omori Factory.
How much will a valve job cost on a ford ranger?
It depends on if it is a 4 cylinder or 6 cylinder. If you do the leg work to remove the head(s) and take them to an engine shop it should be no more than $250 per head. I just had my 4 cylinder done for $215. Expect to pay much more if you cannot remove and re-install the head yourself. $65+ an hour for a mechanic to remove and install the heads.
How much horsepower does a RB20det have?
217 is your horse power
Is there a difference between a cylinder head a head cylinder?
No
The cylinder head is where?
The cylinder head is located on top of the engine. The spark plugs thread into the cylinder head(s).....
How do you change head gasket on 1.8 L VW Passat engine?
Remove the cylinder head from your VW engine. Remove the head gasket and clean the head gasket surface. Put the new head gasket on and return the cylinder head to its original position.
How can a blown head gasket be fixed on a 95 kia sportage?
Basically: pull cylinder head, remove old gasket, install new gasket, put cylinder head back. Do note that this is a simplification, there are plenty of intermediate steps I haven't listed. Odds are, if you have to ask you don't have the skills to do the job.
If you have a crack cylinder head can you have your cylinder head be refaced?
Cracks can be welded and then the head can be resurfaced.
