The is to Bring the engine to TDC ( Top Dead Center ) you can do this by removing the drivers side valve cover and watching the intake valve.. crank over the engine until that rocker arm opens then closes... also there is a timing hash and timing mark on the timing cover, and harmonic balancer. once this is done set the rotor on the distribur so that once it is in the motor it points the Cylinder #1... then install dist cap, then adjust timing using a timing light....
Hope this helped...
How do you install a new heater core on a 1979 chevy monte carlo?
distributor module
That is the ignition coil.
The same as it was before.
You don't, it's blasphemy...
350 turbo automatic
A 79 shouldn't have points to gap. It should be an HEI distributor.
The 1979 Chevrolet distributor to the dashboard wiring diagram can be obtained from most Chevrolet dealerships. The wiring diagram can also be found at many auto-parts stores.
The weight of a 1979 Chevy Silverado camper special with a 400 tyranny is about 3,342 lbs. In the years 1973-1979 the truck weight did not change.
The 1979 Chevy Silverado glove box latch is held in place with two retaining screws. Remove the retaining screws and the glove box latch will come off.
You need to run a switched, full-voltage wire to the "bat" terminal.
1-8-4-3-6-5-7-2