FIRST OF ALL YOU HAVE TO FIND OUT WHICH WIRE IS YOUR INCOMING POWER AND WHICH ONE GOES TO DEVICE. MOST ANYKIND OF ELECTRICAL VOLTAGE TESTER WILL WORK THAT GOES UP AND ABOVE WHAT YOU ARE TRYING TO TEST. GENERALLY SPEAKING THERE WILL BE A BLACK AND WHITE AND POSSIBLY A GROUND IN ANY OF THE CABLES COMING IN AS LONG AS ITS NOT A FOUR WAY OR THREE WAY.THE BLACK WIRE IS SUPPOSED TO BE THE HOT WIRE COMING IN AND YOUR WHITE IS THE NEUTRAL. THE BLACK WIRES ARE THE ONES THAT ARE SWITCHED AND ARE ATTACHED TO SWITCH ON THE SIDE . ON A SINGLE POLE IT DOESNT MATTER WHICH ONE GOES ON THE BOTTOM OT THE TOP THE SWITCH ,IT WILL STILL BREAK THE FLOW OF ELECTRICITY . THE WHITE WIRES ARE TIED TOGETHER AND PLACED AS FAR FROM ANY OF THE HOT FEEDS AS POSSIBLE FROM THE BLACK SWITCH LEGS. IF YOU HAVE THE GROUND WIRES , TWIST TIGHT TOGETHER LEAVE ONE OF THE WIRES LONGER AFTER TWISTING TO ATTACH TO THE GREEN SCREW ON OUTLET FOR GROUNDING IF NEW WIRE. OLDER HOUSES ( 50 YEARS OR SO DIDNT HAVE GROUND WIRES . ATTACH TO BOX AND MAKE SURE YOU HAVE VOLTAGE TO THE SWITCH BEFORE ATTACHING THE COVER.
See Discussion page
An old/worn/faulty light switch, or the wires connected to the switch are loose. Replace the switch ASAP.
its probably old get an electrician to replace it
Light switch connection is usually straight forward. Find your incoming hot wires, black and white. With the switch in the off (down) position and the power disconnected , connect the black wire to the top screw of the switch. Find the load wires and connect the black to the bottom screw of the switch. Connect the two remaining white wires together with a wire nut and push them to the back of the switch box. Install the switch into the wall box, replace switch plate cover. Turn the breaker (power) back on. Flip the switch to the up position and the light should come on.
If the question is, can I wire a switch to an existing light fixture (and I must assume that it's something like a pull-chain light fixture), the answer is yes.If the question is, "how do I wire a switch to an existing light fixture that has no external switch", the answer is, "in series".The attached web site gives simple instructions on how to wire a basic light switch to an existing light.See sources and related links below
A light that is mounted on the ceiling.
brake light switch is mounted by the brake pedel remove lower panel above brake pedel and then you will see the switch should be able to turn the switch to replace
Probably an improperly adjusted brake light switch, or a defective switch. The switch is a simple device mounted to the brake pedal - easy to check and easy to replace.
How do you replace a break light switch on 1995 Chevy Tahoe
The combination neutral start and backup light switch is mounted inside the shifter housing. Remove the screws holding down the shifter housing and remove the switch. Adjust the switch by moving it on its mounts.
replace head light switch on 93 ford explorer
how to replace the brake light switch at the pedal of a 2001 ford zx2
the reverse light switch is usually mounted on the shifter inside the car.
Go to the brake pedal and it is mounted under there then unplug the connector and screw out the part then screw the new one in and replug the connector in.
replace it
An old/worn/faulty light switch, or the wires connected to the switch are loose. Replace the switch ASAP.
mounted on the trans
It is mounted on your transmission