answersLogoWhite

0

Turn the dial to the omega symbol.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the cause if a multitester is in the ohms position but the meter pointer cannot be set to zero when the test leads are shorted and the ohms adjust control is turned?

check the batteries


How can I check the resistance in a wire?

To check the resistance in a wire, you can use a multimeter. Set the multimeter to the resistance (ohms) setting, then touch the probes to each end of the wire. The multimeter will display the resistance measurement in ohms.


How do you use a micronta no 22 - 027 multitester?

To use a Micronta No. 22-027 multitester, first ensure the device is set to the correct measurement mode (voltage, current, or resistance) by turning the selector knob. For measuring voltage, connect the red probe to the positive terminal and the black probe to the negative terminal of the circuit. For resistance, connect the probes across the component and read the value on the display. Always start with the highest range setting to avoid damaging the meter, then adjust as necessary for more accurate readings.


How do you set up digital freeview satellite in Germany?

Check it on GoFreview.com, you might find it there !


How do you check resistance on coil pack 2003 trailblazer?

To check the resistance on a coil pack for a 2003 Trailblazer, first, disconnect the electrical connector from the coil pack and remove it from the engine. Use a digital multimeter set to the ohms (Ω) setting, and measure the resistance across the primary terminals (usually the two larger pins). The typical resistance should be between 0.5 to 2.0 ohms. If the reading is outside this range, the coil pack may be faulty and should be replaced.


What is a multitester scale?

A multitester scale refers to the range of measurements that a multimeter can make, such as volts, amps, and ohms. It provides a set of divisions for each unit of measurement that allows users to accurately read the values being measured. Different multitesters have different scales to accommodate various ranges of measurements.


Do the colour code readings tally with the resistance values obtained using the digital multimeter?

Yes, the color code readings should match the resistance values obtained using a digital multimeter, as the color bands indicate the resistor's nominal resistance. However, discrepancies can occur due to factors such as tolerance, temperature coefficient, or measurement inaccuracies. It's essential to ensure the multimeter is calibrated and set correctly for accurate readings. Always cross-check the resistor's color code and the multimeter reading for consistency.


How do you test a camshaft position sensor on a ford focus?

Using a Digital Multimeter set to 2k,..the resistance should be 200 to 900 ohms ifnot replace,


How do you check a 6v regulater delco?

That depends on what you're trying to check, exactly. If you want exact voltage, you'll need either an analog or digital multimeter, unless you have the high end Snap-On test light which displays voltage on an LCD display. If you're trying to test resistance, you'll need a digital multimeter, as well. You'd remove the regulator, set the DMM on the ohms setting, and place the probes in contact with the regulator input and output.


Can I connect a timer to my digital camera so that I can also be in the picture?

Many of the newer digital camera's come with built in timer's so you can set it and join in! Check your manual that comes with the camera for specific instructions.


How do you check if a diode is serviceable?

use a vomm set to infinite resistance if you have reistance one way and not the other way. diode is good (must be isolated from circuit) if no resistance both directions diode D.O.A.


Were will resistance 3 be set?

Resistance 3 will be set somewhere within the United States of America during the 1950s.