Want this question answered?
adjust
No, the word "adjust" is not an adverb.The word "adjust" is actually a verb, since it is an "action word".
Adjust is a verb Other forms of adjust are: adjusts adjusted adjusting
adjustment
It's ASCII adjust after addition
· Engineer`s squares require no adjustment because they are fixed, however, they must be checked regularly for squareness· Vernier height gauges, vernier callipers, vernier protractors and combination squares slide back and forth to the requires height/width/depth/angle and then a thumb screw is used to lock them into position· Dividers are spring loaded, and can be set using a steel rule to ensure accuracy
It is very easy to adjust the handbrake on a Vectra C. All you need to do is remove the rear console and release the handbrake. Under the handbrake is a cable with a white end fitting, push down the end fitting onto the plastic locking device. Then pull the lever and it will be adjusted.
First, open the hood to reveal the car's engine compartment. Then find the right fitting to adjust the rocker arms. Use the tool to adjust the rock arms to desired area.
Dennis G Milbert has written: 'ADJUST' -- subject(s): Computer programs, Least squares, Geodesy
You will need to loosen and adjust the hinges. They are probably worn out and need replacing. Open the door and lift up on it. If you feel play, then the hinges are worn.
Chocolate chips have sugar and other ingredients in them. Bakers squares are usually just pure unsweetened chocolate. You could probably substitute but need to adjust sugar in your recepie.
-Depress and hold down metal re-adjust tab at engine end of T.V. cable. -Move slider until it stops against fitting, then release re-adjust tab. -Rotate throttle lever to its "full travel position". -The slider must move (ratchet) toward the lever when the lever is rotated to its "full travel position".
My '98 has rods coming off of the headlight assy that have a fitting in the end for a Torx driver. There are two different adjustments: one for horizontal, one for vertical. Good luck!
Snapback refers to the size-selectable 'poppers' at the rear of a hat, which make a snapping sound when you open and close them to adjust the fitting size. Other cap fitting types are 'fitted' (which come in fixed sizes such as 5 1/4 inch), FlexiFit (slightly stretchy, one size fits all type) or strapback (with a catch mechanism allowing you to fine-tune the fitting). Flat peak refers to caps that are sold with a flat peak as opposed to a curved, formed peak. So it is possible to have a flat peak or a curved peak with any of these fitting types.
Cook at 25 degrees less heat than recipe advises. Also cook on top rack in top 1/3 of oven.
Make sure that the rear brake adjusters were backed all the way off when fitting new pads. Once complete adjust up pads if manual adjuster or rely on automatic adjusters to do this, then adjust brake cable.
The future tense of adjust is will adjust.