0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is a segment on infinitive set of points?
No, but is an infinite set of points.
Set of points on same straight line?
A set of points on a straight line are called 'collinear points'.
What is the set of all points representing solutions?
The solution set is the set of all points representing solutions.
A set of points all of which lie on the same straight line?
Collinear set of points
What is the infinite set of points that is straight and terminates at its end points?
An infinite set can not terminate.
What is the points gap on a 350 Chevy?
When set properly, the gap would probably be about .018". The correct way to set the points would be to hook up a dwell meter and adjust the points for 30 degrees dwell.
What is the plug gap for the 1930 Model A?
Gap the spark plugs to .035. Set the points to .018.
What is the set point gap on a 96 impala?
There are no points on a 96.
How do you gap points?
I remove the distributor and rotate until the points are at the widest opening. Then using a .017mm fueler Gage I set the point gap. Reinstall the distributor, set timing and roll!
How do you time a lawn mower engine?
On most lawn mowers there is no timing - they have the flywheel set, as long as the shear pin is in place, it will put the magnet by the coil at the proper time to fire. The points are run by the gap (you set the gap on the points) and the pin pushes the points open at the proper to fire. The only setting you have to do is the gap on the flywheel to the coil and the gap on the points.
What is the ignition gap points dwell for a 1973 Pontiac 400?
If you set the points at 30 degrees you will be fine.
Points gap 4.5 merc outboard?
The maker points on the 4.5 hp Mercury outboard, are set at 0.020 in.
What is the point gap for a Toyota 4y motor?
Most points will set at 15 thousandths.
What are the point gap settings for a Massey Harris Pony?
the points should be set at 0.020"
What is the proper points gap on a 1970 9.8 Mercury?
The maker points on a 9.8 hp Mercury outboard should be set to .020 in.
What is gap on 302 changed from points to electric ingnition?
set the plugs at .040 and all will be good.
How do you set the points on 1972 350 Chevy with a 4 barrel carb?
Use a dwell meter to set the gap at 30 degrees.
