0
If you are working with pipes and unsure of the pipe sizes, carry a vernier caliper with you to check pipe sizes, it also fits in your pocket for easy transport
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What has the author FR Law written?
F.R Law has written: 'Dimensions and weights of pipe and fittings'
What is the importance of dimensioning?
To solve problems it is important that the dimensions of the answer are those that are input to the problem. In Engineering the dimensions of an item are important so that it withstands the loads it is subject to.
What is dimensional analysis?
a way to analyze and solve problems using the units, or dimensions, of the measurements.
How much water does a pipe 6 inches in diameter times 500 feet long?
A pipe does no water. Te capacity of the pipe with the given dimensions is approximately 98.2 US gallons. Whether or not the pipe holds any water is impossible to say.
How do you work out x dimensions?
measure the length of the fitting first. Then insert pipe into fitting and mark a line on pipe. measure that bit of pipe. deduct off the length of fitting and half it to give you your x dimension
What are some mysteries for you to solve?
If you mean what I want to solve, then I would have to say Aliens and other life forms. I believe that we're not alone in this universe and that there're many other dimensions all with a negative and positive side both leading into more dimensions with the same positive and negative side, meaning that there's infinite amount of dimensions.
What is the surface area of a pipe 48 inch diameter 500 feet long?
The external surface area of a pipe is a rectangle with dimensions of the circumference of the pipe multiplied by the length. 48*pi*500 24000*pi square feet about 7550208 square feet
What dimensions should be added to steel pipe to allow for threads?
1 and 1/2 inches.Depending on the piping diameter one normally would figure for a 1/2" pipe 1/2 for threads
How many square meters in a 10 linear meter pipe which is 12 inches in diameter?
This question cannot be answered sensibly. The required measure of the pipe is that of a volume which has dimensions [L3]. A square metre has dimension [L2]. Basic dimensional analysis teaches that you cannot convert between measures with different dimensions such as these without additional information.
How do you solve the problem of Dishwasher waste and washing machine waste and one waste pipe?
Buy a branch connector
Does overflow of fuel in the carburetor cause the engine not to start?
Yes. to solve the problem strangle the fuel pipe to cut flow of fuel and persistently start the engine it should solve the problem.
What is the formula to ending-to-center dimensions on a long radius butt-weld elbow?
1 1/2 times the nominal pipe size
