If you are adding a new light, do not touch the old nob and tube. It is out dated and you should be in the precess of removing it. Never add tonob and tube. If you are just replacing a light fixture you want to put the new fixture back the same way you took the old one out. You need to take extra care not to move or disturb the wires too much. The old insulation can become brittle and break off. In general if you still have knob and tube you should start the process of replacing it.
Turn the light nob to the left and a orange light should come on under the lights nob.
turn nob all the way to the right and pull the nob out towards you ( away from the dash)
On the left side of the front dash by the reading gauge there is a nob that looks like an oven nob, turn the nob to the left to turn the lights on. Below that is the wheel to brighten or lessen the reading gauge panel.
Yes there is. You simply twist the tachometer reset nob counterclockwise to dim.
at nob street
Good question. It depends on your point of reference. If you Look UP at it while it is installed on the ceiling, then use the nob or pulley that controls the fan to use as the 12 marker on the clock. If it goes to the right its clockwise and to the left it is counter-clockwise
You should turn the lights on, (should be a nob thing that you turn) just give it a pull and it should slide bank and your spots should be on. One more light pull the fog light will go on.
Nub's Nob was created in 1958.
What is NOB ??
because Tim is a nob because Tim is a nob
Nob Nation was created in 2006-11.
The duration of Nob Nation is -300.0 seconds.