You would need to check for other lights on the same circuit or switch, but it would seem to me that you have power coming into the box (black and white) and a power out going to another box or light. You would use wire nuts to connect the black and white wires from your floodlight to the existing ones.
In parallel. Black to black, white to white and ground (bare) to ground. You need to make sure you don't overload the circuit. You would measure what current you are drawing now and add the additional requirement for floods and that total current should be 80% of the value of the breaker protecting the lighting circuit.
Piggyback off the box for the existing light. Run a wire from the existing junction box to a new junction box (which is placed wherever you want the new fixture). Then, in the existing box, connect the wire coming from the switch, the wire for the existing fixture, and the wire for the new fixture together using wire nuts. Wire up the new fixture, and presto, you have two fixtures on a switch where there was only one before.
No, flood lights do not use more energy. If the wattage is the same between a flood and a spot light, it is the wattage used that you pay for. It is the lens of the bulb that determines the light output pattern. A smooth surface will give a flood pattern where as a spot has a lens that focuses the light into a central location. A reflector flood has a silvered interior to direct the light outwards on to an object.
Not enough information. Lights? Pumps?
Typical flood lights use between 75 and 300 watts per bulb. Many fixtures have more than one light bulb, and many home installations have more than one fixture. Yes, flood lights use a lot of electricity. The figures can be brought down a bit by using mercury vapor or halide lamps.
check the fuse, if it is not blown, your tail lights may be missing ground, locate the ground wire on your tail light socket, then get a wire and a metal thumb tack, push the thumb tack thru the ground wire and splice the extra wire and wrap the bare wire around the thumb tack, turn your tail lights on and touch the bare metal of your van and see if it lights up, if it does lights up, just splice it and reconnect to the new ground source, hope this help you out :-)
The only difference between LED lights and your old lights is the bulbs. Wire the new lights up using your existing wires and you'll be fine.
form_title= Flood Lights form_header= Brighten up your home with flood lights! How many flood lights do you want to install?*= {1, 2, 3, 4, 5, More than 5} Will you be doing the installation yourself?*= () Yes () No Do you want lights that turn on automatically?*= () Yes () No
to wire the license plate lights you must have lights and wire them to the scooter.
1778
A convex mirror is present inside flood lights.
Fog lights use special brackets which sit recessed on a 2001 Chevy Cavaliers bumper. To install the fog lights mount the units into the bumper brackets. Then splice the fog lights into the existing wire harness. Use a switch if necessary.
Piggyback off the box for the existing light. Run a wire from the existing junction box to a new junction box (which is placed wherever you want the new fixture). Then, in the existing box, connect the wire coming from the switch, the wire for the existing fixture, and the wire for the new fixture together using wire nuts. Wire up the new fixture, and presto, you have two fixtures on a switch where there was only one before.
how do i wire my brake lights on my Honda 1000
Had the same problem with 306 rear lights. Spliced a new piece of earth wire into the existing wire and to a good earth point, thios solved the problem.
In flood lights,the source of light is placed between the pole and focus of a concave mirror so as to obtain a diverging beam of light..
short in the wire or they are all on one wire
Neither, both can be brighter and dimmer based on the efficiancy it is set to. BUT spot light are a more concentrated light while flood lights are meant to "flood the stage" with light. hope this helps. ~theatre nerd