0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How much drop PER FOOT needed for 300' of pipe?
Drop per foot doesn't care about length of run, it depends on pipe size. Pipe larger than 2" needs only 1/8" per foot (37.5" fall for 300'), 2" and smaller needs 1/4" per foot (75" fall for 300')
What is the use of overflow pipe?
To drain the over flow from a tank or fixture
How many gallons of water per foot will a 3 inch diameter pipe hold?
Over 9,000.
How do you calculate volume of water in a pipe?
measure the radius of the pipe. (half the diameter - the width of the pipe) then measure the length of the pipe. then use the formula pi (3.14) x radius2 x length. the answer is the volume in the pipe
A piece of pipe is 303.4 inches long If five pieces each 41.3 inches long are cut from the pipe how many inches of pipe remain?
A piece of pipe is 303/4 inches long. If five pieces, each 41/3 inches long, are cut from the pipe, how many inches of pipe remain?
How do you calculate lineal meter of a pipe?
pipe length = 5487mm pipe size = 6inch
How much fall in a toilet drain pipe?
From various sources I gathered that the minimum fall (slope) is 1cm fall over 1m distance. Converted that is 0.125 (1 eighth) inch fall over 1 foot distance.The maximum that should not be exceeded is 1cm fall over 20cm distance. Converted that is 0.25 (1 quarter) inch fall over 4 foot distance.
What is peracentage referring to fall of pipe?
1 %
Deterimine the volume of a 6inch pipe that is 5280 feet long?
It is pi (roughly 22/7) x r x r (i.e. 9) x 5280, the answer being in cubic feet - but you can do the math.
How do you pass stage 18 in this is the only level?
you have to go ABOVE the pipe and fall into the pipe ;) since the level is falling bricks just goby the pipe and youre there
What is roughness ratio?
In a pipe it is the roughness of the pipe over the diameter of the pipe
Are pipings and pipe fittings the same?
No, fittings go over the pipe
What is the fall on a sewer pipe?
1/4" per foot normally
How do you get out of bowser on bowsers inside story?
You get hit by a laser. then you fall down and the pipe yard inside bowser opens up and you get out through a pipe
Is galvanised pipe a smooth pipe?
Not really, there are tiny lumps all over most of it.
When a turning fork vibrates over an open pipe and the air in the pipe starts to vibrate the vibrations in the tube are caused by resonance?
When a tuning fork vibrates over an open pipe and the air in the pipe starts to vibrate, the vibrations in the tube are caused by resonance.
What is Plumbing pipe pitch?
Plumbing pitch is the amount of fall you have on your waste. All waste, not on a pump system, has to have fall toward the destination of the waste (septic tank, sewer, etc.) The pitch is basically a downhill tilt of the pipe it requires to drain the liquid and solid waste from the pipe utilizing gravity. standard fall on a waste pipe is 1/8 of an inch per foot. the reasoning behind this is that your solid waste runs with your liquid waste minimizing clogs and optimizing drainage.
