In a pipe it is the roughness of the pipe over the diameter of the pipe
someone do my homework thx
12 is a single number. In so far as it can represent a ratio, it is a ratio of 12 to 1: a unit ratio.12 is a single number. In so far as it can represent a ratio, it is a ratio of 12 to 1: a unit ratio.12 is a single number. In so far as it can represent a ratio, it is a ratio of 12 to 1: a unit ratio.12 is a single number. In so far as it can represent a ratio, it is a ratio of 12 to 1: a unit ratio.
The ratio of all lengths is the same. The ratio of the circumferences = ratio of the radii = 2:3
ratio of volumes is the cube of the ratio of lengths radii (lengths) in ratio 3 : 4 → volume in ratio 3³ : 4³ = 27 : 64
The golden ratio, or golden mean, or phi, is about 1.618033989. The golden ratio is the ratio of two quantities such that the ratio of the sum to the larger is the same as the ratio of the larger to the smaller. If the two quantities are a and b, their ratio is golden if a > b and (a+b)/a = a/b. This ratio is known as phi, with a value of about 1.618033989. Exactly, the ratio is (1 + square root(5))/2.
this is found by multipling the denominator of one ratio by the numerator of the other ratio
Roughness lol
Relative roughness is a measure of the surface roughness of pipe surfaces. It is the size of the roughness scaled by the diameter of the pipe or duct. Rel Roughness=e/D; where e is the measurement of the surface roughness and D is the diameter of the pipe. It is mainly used for calculating head losses in piping systems.
surface roughness tester is the machine which used to measure the roughness of the surface using probes... roughness is nothing but the frictional force applied by the surface to the adjacent surface.. if roughness increases the amount of frictional force increases..
The Absolute roughness, e, of copper is 1.5 microns The relative roughness is just e/D
The director of Necessary Roughness was Stan Dragoti.
The difference between roughness and flatness is that one, flatness, is the shape of an object. Roughness is the surface or texture of an object.
A roughness value can either be calculated or measured on a profile or on a surface. The profile roughness parameter are more common. The area roughness parameters give more significant values.
He would have been a more successful orator, if not for his roughness in a sentence. The roughness of the shale tore a hole in my pants when I slid down the embankment. I use sandpaper to reduce the roughness of the cabinet's surfaces.
One instrument used to measure roughness of roads is the response type road roughness meters (RTRRMs)
The duration of Necessary Roughness - film - is 1.8 hours.
Necessary Roughness - book - has 240 pages.
Necessary Roughness - book - was created on 1996-11-20.