answersLogoWhite

0


Best Answer

it should be 5 feet

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How high above a metal roof should the electrical service be located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Electrical Engineering

What is an electrical service mast?

A service mast is attached to the building, it stands normally above the building or at the highest point of the building, were no one can get to it. The service mast contains the wires from the meter base to the top of the service mast, this is were the power company attaches it wires so that the building has electricity.


What is meggers?

A megger is an electrical instrument that is used to measure the resistance of insulation by applying a DC voltage to the conductor. One lead is connected to the conductor and the other lead is connected to ground. Safe insulation reading to ground should be above 2,000,000 ohms or 2 megs.


Can the electrical panel be installed above a base kitchen cabinet or does the floor space in front of the panel have to be open?

No, you should not install anything in front or below the panel. You must have 36" of free space in front of the panel and 30" on either side of the panel.


How do you install a 3 phase electrical service?

The same as a split single phase service, except with 3 phase panelboards, and the size of the service equipment can differ greatly. If the service voltage is 480v, you'll have to install your own transformers to use 120v equipment. I'm not sure as to the purpose of this question. If you're trying to do it yourself, you probably shouldn't have to ask how. It's a pretty large thing to do. If you're just curious, the above answer should suffice.


How high above a electrical panel can you install a gas furnace?

It is different in different states. You are dealing with 2 separate codes here. HVAC & Electric codes. Contact both your electrical inspector and whoever inspects gas HVAC for a definite answer.

Related questions

Where should a drain taps internal service pipework be located?

immediately above the stop valve


A water service pipe and building sewer are installed in the same trench where should the service pipe be located?

ABOVE the sewer line and on an angle away


Where should you never place electrical cords?

all the above


Where is the O2 sensor located on a 1999 Kia Sephia?

There are 2 sensors. The front sensor is located on exhaust manifold.Its electrical connector is located to the left of the cylinder head, above the transaxie.


Where is the blower motor resistor on a 95 Bonneville SE?

The blower motor resistor is located just above the blower motor under the hood. It should have an electrical connector plugged into it and some screws holding it in place.


How do you replace a fuel pump on a 95 olds cutlass supreme 3.1 its electrical?

you have to drop the gas tank,the pump is located above and inside it.


What is an electrical service mast?

A service mast is attached to the building, it stands normally above the building or at the highest point of the building, were no one can get to it. The service mast contains the wires from the meter base to the top of the service mast, this is were the power company attaches it wires so that the building has electricity.


What is the mathematical relationship between electrical conductivity siemens and the unit volt ampere?

http://everything2.com/index.pl?node=electrical%20conductivity I think the above link should answer this question.


What is mean electrical power triangle?

the electrical power triangle is as shown in the above pictiure


The heart is located above what?

it is located above the diaphragm


Where is the PCV valve on 1998 civic ex?

Should be located just above the oil filter.


Which type of sources can result in burns?

Thermal, Electrical, Chemical (All of the above)