answersLogoWhite

0


Best Answer

It slides under the first mat section

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How is the 90-degree connector attached to the mat assembly?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

The joins two mat areas at a right angle and allow the mat to be slipped into place without the need for any special tools?

90-degree connector


The location of the aircraft tiedowns must be determined prior to mat assembly?

False


The area between the mat assembly area and the crater must be cleared?

true


Why is bundle placement a key factor in the AM-2 assembly process?

Place the bundles too far away and your crews will be overworked carrying the mat to the assembly area Bundles placed too close to the assembly area will cause your crews to waste time moving the mat out of their way


The area between the mat assembly area and the crater must also be cleared?

True


Can you buy a dance dance revolution mat connector for ps2?

yes i think they still have some left in gamestop


Where is the diagnostic connector on a Peugeot 307?

It's in the center console, right under the ashtray. Just remove the rubber "mat" that sits under it and you'll find the OBD connector. // Jan, Finland


Where is the diagnostic connector on Peugeot 307?

It's in the center console, right under the ashtray. Just remove the rubber "mat" that sits under it and you'll find the OBD connector. // Jan, Finland


Where is the diagnostic connector on a 1994 Mitsubishi Galant?

Move the drivers seat all the way back. Laying down on the drivers side floor mat look up to your left and towards the back of the vehicle you will see two(2) connectors. The connector that is next to the trim panel is the diagnostic connector


What is the function of anti static mat?

An anti-static mat is usually made of a conductive plastic. Usually, on one corner there is a snap connector. From that snap connector there is a long, (usually GREEN) wire, as well as a coiled wire that goes to a wrist strap. The green wire goes to the round GROUND connector of an AC wall socket. The coiled wire that goes to a wrist strap goes just like that. Wrap the wrist strap around your wrist. The reason for this setup is, through the green wire to the ground connector, you put both the mat and your body at ground potential. It takes the static electricity from your body,via the wrist strap, and from the mat to ground. Be VERY CAREFULL!! YOU MUST KNOW WHERE THE GROUND IS ON AN AC OUTLET TO USE THIS AS I HAVE OUTLINED. If you do not know where the ground pin is on an AC outlet, you should not use it.


The mat assembly area must be large enough to?

unfold both mats without hindering the crushed stone crater repair operations


Where is mat sensor located on 96 Geo Metro?

firewall, right side, has 1 elec. plug and one vac hose attached.