It is not any different except that it cannot be located within reach of the tub or shower.
the oulets yes the switches would be a no
Dimmer switches go bad, more often than regular switches.
It is dependant on whether the switches are in wired in a parallel or series configuration. If the switches are wires in parallel then both switches would have to be off to turn the light bulb off. Either switch could turn the light bulb on. If the switches are wired in series then both switches would have to be on to turn the light bulb on. Either switch could turn the light bulb off.
No. A double pole switch would be a switch that switches 2 different loads simultaneously. 3-way switches (and 4-way switches if more than 2 are used) are what are used for controlling a light from multiple locations. While a typical single pole switch simply opens or closes a single contact, a 3-way switch provides a path from a contact point to, let's say, point A or point B. Points A and B from the first 3-way switch are connected to points A and B of the second 3-way switch and then the common contact point of the second switch is connected to your light. When more than 2 switches are desired, you can use any number of 4-way switches between the 3-way switches, but the 3-way switches MUST be on the ends of the circuit.
A pull-string or pull-chain switch IS a light switch. Some other types of light switches are called wall switches and cord switches.For more information see the answers to the Related questions shown below.
Mercury tilt switch, Knife switch, Footswitch, Reversing switch, Light switches, Electronic switches
the oulets yes the switches would be a no
In a light switch factory......
That's one I've never seen. Does the bathroom light turn ON when the bedroom light is switched Off? Does the bathroom light switch turn the bathroom light on and off normally when the bedroom light switch is left on? Need to answer these questions, then find where the bathroom light power comes from. It's power supply should either go directly from the power oanel to the bathroom light or to the bathroom light switch. The bathroom light switch merely acts as an interrupter for the hot leg of this power supply.
It's easier to handle.
To make it easier to use. I prefer a light switch on the outside of the bathroom because it makes it easier to find especially if I am in a hurry.
I have never seen a bathroom light switch with a cord hanging from it and I've seen a lot of bathrooms. But if i had to guess. I'd probably say to turn them off. Electricity is conducted very easily through water. So if you let water run from your wet hands into a light switch in a bathroom there is a chance you could get a shock, even get killed. So some bathrooms have the switch on the roof with a long string to turn it on and off. So there is no chance of water getting to the switch.
Dimmer switches go bad, more often than regular switches.
It is dependant on whether the switches are in wired in a parallel or series configuration. If the switches are wires in parallel then both switches would have to be off to turn the light bulb off. Either switch could turn the light bulb on. If the switches are wired in series then both switches would have to be on to turn the light bulb on. Either switch could turn the light bulb off.
Send power to the 1st switch and then send the power from that switch when it is in the on position to the second switch. Then send power to the light from the second switch. That way both switches will have to be in the on position for the light to be on.
the switch is to control the light if this is turn on or turn off
Most light switches can be in two states, on or off.