As a continuous load your TVs have to add up to 12 amps or less. There will be a rating plate on TV. At about 3 amps per TV would allow 4.
It depends on how many amps each TV draws. The continuous load should be 80% of teh breaker or 12 amps. If an average TV draws 2.5 amps that would be 4 TVs. Look for a rating plate on TV and just add the currents up.
If there is any additional load on the outlets greater than 2.5 amps the breaker will trip. Loads of 1500 watts should be on a dedicated breaker. If the total load exceeds 15 amps the breaker will operate. However many of the outlets might supply only lights, TVs or nothing at all, so in those conditions it's OK.
Yes, if you are using AWG # 10 wire. If you are using AWG # 12 then the answer is no you must use a 20 amp breaker. On AWG #14 wire you must use a 15 amp breaker.
A 32 amp fixture can not be fed from a 20 amp breaker as the breaker will trip every time.
A 15 amp breaker is not sufficient for a 225 amp load. You would need a breaker that matches the load current, such as a 225 amp breaker. Using a 15 amp breaker for a 225 amp load would cause the breaker to trip immediately due to overcurrent.
Replace the 30 Amp Breaker with a 15 Amp breaker.
It's the amps that are controlled by the breaker not the volts. You can have a 600 volt 15 amp breaker, you can have a 347 volt 15 amp breaker. The breaker will trip when you exceed 15 AMPS.
The breaker commonly used for ranges is a 40 amp. This size is used to cover the total wattage of the range. If for some reason all of the top elements and the oven were in use at the same time then the amperage drawn would be just under the trip setting of the breaker. If this same scenario were played out on the range with a 30 amp breaker supplying the power it would trip the breaker.
A 50 amp breaker is an overcurent device.
No, you should not replace a 15 amp breaker with a 20 amp breaker without consulting a licensed electrician. The breaker size should match the wire size to prevent overheating and potential fire hazards.
You have a double pole breaker for 240Volt supply. The maximum current is 15 amp.
Yes, considering you can do that on 15 amp breaker easy.Experience in construction field. The worst that will happen is that the breaker will trip off after a few minutes.In the formula W = A x V. W = 20 x 120 = 2400 watts. If you want you can operate two 1000 watt lamps from a 20 amp breaker operating on 120 volts.